HP Integrating Protected HPE Storage Solutions - HPE0-J50 Exam Practice Test
A storage integrator is handing over an installed HPE 3PAR storage system to a customer. The customer wants the original license key of the system for setlicense command that is used to prevent the system from prompting for confirmation of new license key.
Which of the following command shows original license key?
Which of the following command shows original license key?
Correct Answer: C
Vote an answer
Refer to the exhibit.
An Integrator is configuring File Persona on a HPE 3PAR StoreServ 8440.
What is a valid Netmask for the configuration shown?
An Integrator is configuring File Persona on a HPE 3PAR StoreServ 8440.
What is a valid Netmask for the configuration shown?
Correct Answer: B
Vote an answer
A storage integrator is planning the implementation of a single HPE StoreOnce 3100.
How many power cords are required to be connected to PDU from this storage system, when power supply kit was ordered?
How many power cords are required to be connected to PDU from this storage system, when power supply kit was ordered?
Correct Answer: B
Vote an answer
A storage integrator installed an HPE 3PAR StoreServ system.
For which default accounts will the storage integrator need to hand over changed passwords to the customer?
For which default accounts will the storage integrator need to hand over changed passwords to the customer?
Correct Answer: A
Vote an answer
Click the menu option a storage integrator will use to install a new StoreOnce VSA solution.
Correct Answer:
Explanation
References:
Refer to the exhibit.
A storage integrator is creating a virtual volume on an HPE 3PAR StoreServ storage system and plans to create clones of the volume in the future.
Which additional steps will be required for this? (Choose two.)
A storage integrator is creating a virtual volume on an HPE 3PAR StoreServ storage system and plans to create clones of the volume in the future.
Which additional steps will be required for this? (Choose two.)
Correct Answer: B,D
Vote an answer
When using the CLI for performance monitoring on an HPE 3PAR array, for which component in the datapath would the "stavlun" command give an output? (Click on the correct option.)
Correct Answer:
Explanation
3