Oracle Communications Session Border Controller 7 Basic Implementation Essentials - 1z1-404 Exam Practice Test

A. You can configure more than one SIP interface per realm.

B. You can associate multiple realms with a single networkinterface.

C. You can associate multiple home realms with a single network interface.

D. You can associate multiple network interfaces with a single realm only when either TCP or UDP is used as the transport protocol.

E. Although you can use both TCP and UDP concurrently as the transport protocol, you can only have one SIP interface per realm.

A. The switchover berpd force commandwas executed to do a manual failover.

B. The two nodes have different health scores.

C. The training6 peer will wait 1050 ms before considering the training1 peer out of service.

D. The training1 peer is the standby node.

E. The training6 peer is the active node.

A. hostname parameter under the account-config configuration element

B. target name parameter under the bootparam configuration branch

C. hostname parameter under the bootparam configuration branch

D. hostname parameter under the system-config configuration element

E. hostname parameter under the sip-configconfiguration element

A. The Session Border Controller can transmit a different SIP response code than it received.

B. By default, the Session Border Controller will recurse on the 6xx messages.

C. The Session Border Controller will originate a 403 response when bandwidth allocated to a realm has been exhausted.

D. The Session Border Controller cannot originate 3xx class redirect responses.

E. The Session Border Controller will originate a 503 when there are no steering pool ports available.

A. 0

B. 157

C. 161

D. 13

E. 4

A. Navigate to the session-agent configuration element and set the allow-anonymous parameter to 403-forbidden.

B. Navigate to the sip-port configuration element and set the allow-anonymous parameter to realm-prefix.

C. Navigate to the sip-port configurationelement and set the allow-anonymous parameter to registered.

D. Navigate to the sip-port configuration element and set the allow-anonymous parameter to agents-only.

E. Navigate to the session-agent configuration element and set the allow-anonymous parameter to prev-registered.

A. by setting a unique address on the wancoml and wancom2 interfaces via the utilityaddress command

B. by setting the pri-utility-addr, sec-utility-addr, and sec-gateway values to addresses in the same subnet as the IP address configured on the media interfaces

C. by setting the utility address and sec-gateway values to addresses in different subnets as the IP address configured on the wancom interfaces

D. via the utility address parameters on the wancoml and wancom2 interfaces

E. by setting the pri-utility-addr, sec-utility-addr, and sec-gateway values to addresses in the same subnet as the IP address configured on the management interfaces