Avaya Aura Communication Manager Administration - 3100 Exam Practice Test
You must verify in a production system that the number of rings between each point for coverage paths is two rings. You access the system-parameters coverage-forwarding from and check that the value for the local coverage Subsequent Redirection/ CFWD No Answer interval field is set to
2.Which users will be affected by this setting?
2.Which users will be affected by this setting?
Correct Answer: A
Vote an answer
A company is adding a new building to its campus. During construction you receive notice that no one in the Accounting department, which is supported to move the new building when completed, can make an outgoing call.
Which Interface and page or command do you use to begin troubleshooting the problem?
Which Interface and page or command do you use to begin troubleshooting the problem?
Correct Answer: C
Vote an answer
Communication Manager Backups are done through the system management interface (SMI).
Which three statements about the Communication Manager backup function are correct? (Choose three)
Which three statements about the Communication Manager backup function are correct? (Choose three)
Correct Answer: A,C,D
Vote an answer
Which Call Coverage feature enables the call to be sent back to the originator?
Correct Answer: D
Vote an answer
You are configuring Personal Station Access (PSA) and you configure the Communication Manager with the following settings:
-
Set TTI enabled = 'Y'
-
Set PSA Associated code = '25' and disassociate code '#25'
-
Set security code for the station = '1234'
You activate the station by keying in FAC for PSA, station extension number, '#', the security code of the station, and '#'. However, the station is not activated.
Which statement describes the issue to be addressed?
-
Set TTI enabled = 'Y'
-
Set PSA Associated code = '25' and disassociate code '#25'
-
Set security code for the station = '1234'
You activate the station by keying in FAC for PSA, station extension number, '#', the security code of the station, and '#'. However, the station is not activated.
Which statement describes the issue to be addressed?
Correct Answer: B
Vote an answer
What is the maximum number of digits allowed for a FAC?
Correct Answer: D
Vote an answer
Once the route pattern has been designated for ARS, what is the next step?
Correct Answer: A
Vote an answer
Changes performed to Communication Manager are written to volatile RAM.
Which Communication Manager SAT command must be used to copy these changes to the hard disk, so that In case of a loss of power, the changes will be available?
Which Communication Manager SAT command must be used to copy these changes to the hard disk, so that In case of a loss of power, the changes will be available?
Correct Answer: C
Vote an answer
With reference to the Alarm Report shown in the exhibit, which option describes the location of the alarm that occurred on May 13 at 09:25?
Correct Answer: C
Vote an answer
Which signaling protocol registers with Communication Manager?
Correct Answer: B
Vote an answer
Explanation: Only visible for Fast2test members. You can sign-up / login (it's free).