Cisco CCIE SP Written Exam, V3.0 - 350-029 Exam Practice Test

A. Russian Doll Model

B. Class based Model

C. Maximum Allocation Model

D. Global Tunnel Model

E. Policy-based Model

A. BGP weight

B. BGP multihop

C. BGP AS-override

D. BGP allow-AS

A. OSPFv3 uses router ID as a key to encrypt OSPF hello packets.

B. OSPF MD5 authentication uses TCP, and Plan Test authentication uses UDP.

C. To enable OSPF authentication in a network, OSPF area 0 authentication must be enabled first.

D. OSPFv3 supports Advanced Encryption Standard

E. The payload of OSPFv3 packets contains no authentication information.

A. tail-end router

B. head-end router and tail-end router

C. head-end router

D. middle-point router

A. shaping

B. burst protection

C. LFI

D. CIR

A. TTL

B. Label

C. EXP

D. FCS

E. S flag

F. VPI VCI

A. Provides support for intra-AS and CSC scenarios

B. BGP is the preferred routing protocol for connecting two SPs.

C. No requirement for a separate signaling plane

D. Uses separate signaling plane, which provides more security than IPv4

A. two LCCs and two FCCs

B. one LCC and two FCCs

C. one LCC and one FCC

D. two LCCs and one FCC

A. Jitter should be no more than 30 ms

B. One-way latency should be no more than 150 ms

C. Loss should be no more than 3 percent

D. Jitter should be no more than 300 ms

E. Loss should be no more than 1 percent.

F. One-way latency should be no more than 75 ms

A. Receivers are "joined" to the Shared Tree (rooted the rp) by their local Designated Router (DR)

B. Receivers are "registered" with RP by their first-hop router

C. From the RP, traffic flows down a Source Tree to each receiver

D. It does not support all underlying unicast routing protocols like BGP

E. It supports shared trees only assuming all hosts want the multicast traffic

A. It maintains source-specific forwarding state.

B. Membership to a bidirectional group is signaled using explicit Join messages.

C. It reduces memory, bandwidth, and CPU requirements

D. Traffic for a bidirectional group flows along the one shared tree and simultaneously
utilizes multiple paths in a redundant network topology.

E. It does not require any traffic signaling in the protocol

A. It is mainly used in Intra-AS MPLS VPN deployments and is configured at the Router Reflector to avoid misconfiguration in Route Target assignment for VPN configurations

B. It is mainly used in Intra-AS MPLS VPN deployments and is configured at the ASBR to avoid misconfiguration of the Route Target assignment for VPN configurations.

C. It is mainly used in Inter-AS MPLS VPN deployments and is configured at the Router Reflector to avoid misconfiguration of the Route Target assignment for VPN configurations

D. It is mainly used in Inter-AS MPLS VPN deployments and is configured at the PE router to avoid to misconfiguration of the Route Target assignment for VPN configurations

E. It is mainly used in Inter-AS MPLS VPN deployments and is configured at the ASBR to avoid misconfiguration of the Route Target assignment for VPN configurations.

A. telnet 1.1.1.2 /vrf vrf-name

B. telnet 1.1.1.2 vrf vrf name

C. telnet vrf vrf name 1.1.1.2

D. telnet 1.1.1.2 vrf

A. L2TPv3 Frame Relay support includes only 32-bit DLCI addressing.

B. L2TPv3 sessions do not support Frame Relay LMI interworking.

C. Multipoint DLCI is not supported.

D. To use DCE or a Network-to-Network Interface on a Frame Relay port, you must configure the frame-relayswitching command.

E. L2TPv3 feature does not support Frame Relay extended addressing.

A. uniform model

B. short-pipe model

C. pipe model

D. IntServ model