Cisco CCIE Routing and Switching Written - 400-101 Exam Practice Test

A. It supports only IPv6 flows

B. It supports both IPv4 and IPv6 flows

C. It supports a maximum of 2048 entries

D. It uses the default port to send flows to the exporter

E. It supports only IPv4 flows

A. After receiving a BPDU from the root bridge, a non-root bridge waits for the hello interval before forwarding it out.

B. The root bridge sends out a configuration BPDU every hello interval.

C. The root bridge sends out a TCN every max-age interval.

D. The default hello time is two seconds.

A. Colour onbject

B. HOP count object

C. State and attributes object

D. latency object

E. Throughput objects

A. IGMPv3 uses 224.0.0.22 as destination address for reports.

B. lGMPv2 supports explicit source signaling.

C. IGMPv1 supports group-specific queries.

D. IGMPv3 is the first version of IGMP to support a basic query-response mechanism.

E. lGMPv2 supports IGMP querier election.

A. AF13

B. AF41

C. AF11

D. AF43

A. A BGP router with synchronization enabled does not advertise its iBGP learned routes to its Ibgp peers unless it has learned or verified this route on its routing table through an IGP.

B. A BGP router with synchronization enabled does not advertise its eBGP learned routes to its iBGP peers unless it has learned or verified this route on its routing table through an IGP.

C. A BGP router with synchronization enabled does not advertise its eBGP learned routes to its eBGP peers unless it has learned or verified this route on its routing table through an IGP.

D. A BGP router with synchronization enabled does not advertise its iBGP learned routes to its eBGP peers unless it has learned or verified this route on its routing table through an IGP.

A. ICMPv6 is filtered.

B. The MTU size is greater than 1470 bytes.

C. The Do Not Fragment bit is marked.

D. HSRPv6 is configured incorrectly.