Cisco Managing Industrial Networks with Cisco Networking Technologies - 600-601 Exam Practice Test
What are two benefits that are provided by proper grounding and bonding systems? (Choose two.)
Correct Answer: B,D
Vote an answer
You are troubleshooting a connectivity problem and want to isolate the problem. You suspect that a router on the route to an unreachable network is at fault. Which command would you issue to see where the packets stop?
Correct Answer: E
Vote an answer
Which of the following correctly pairs the dotted decimal subnet mask with the correct number of binary bits that represent the subnet mask?
Correct Answer: A
Vote an answer
What is the most critical step to perform when you are using optical fiber connectors?
Correct Answer: D
Vote an answer
Exhibit: Refer to the exhibit. A technician enters the exhibited commands to configure a new router on the plant floor, but receives an error message when attempting to save the configuration. What can the technician do to correct the problem?
Correct Answer: E
Vote an answer
Exhibit: Refer to the exhibit. CCNA.com has the industrial network shown in the exhibit. All switches are configured as layer 2 switches and are using VLAN 1 as their management VLAN. Each VLAN 1 interface has been assigned the correct IP address. What is the purpose of assigning a default gateway to SW-C switch?
Correct Answer: B
Vote an answer
With a Cisco IE 2000 switch, what does a port status LED indicate when it is solid green?
Correct Answer: B
Vote an answer