A2010-577 by IBM Actual Free Exam Questions And Answers

Question 1

After deploying 100 Windows agents using the Client Deployment Wizard, none of the agents are showing up in the IBM Tivoli Endpoint Manager (TEM) Console. The Client Deployment Wizard shows that the agent was installed and the agent is running on all 100 systems. The agent is running on the TEM server and the one agent appears in the TEM Console. What are the two most likely causes of this problem? (Choose two.)

A. There is no DNS entry for the TEM server.

B. Port 52311 is not open from the client to the TEM server.

C. The Windows firewall is active on the client system.

D. The agent install was performed with insufficient credentials.

E. The agent install actually failed even though the Client Deployment Wizard shows success

Discussion 0

Correct Answer: A,B Vote an answer

Question 2

This error message is displayed in the IBM Tivoli Endpoint Manager Client Deployment Wizard: Windows Error: No network provider accepted the given network path.
What are three possible causes of this error? (Choose three.)

A. Insufficient or wrong credentials

B. WMI is disabled on the remote system

C. The system is powered off

D. Windows File and Print Sharing are disabled on the system

E. The Group Policy object is configured to prevent remote software installation

F. The system is protected with a personal firewall

Discussion 0

Correct Answer: C,D,F Vote an answer

Question 3

A customer's IBM Tivoli Endpoint Manager (TEM) implementation has 5300 Windows endpoints. While connected to the TEM Console as a master operator it is observed that that 0 of 0 endpoints are relevant for all content in the Patches for Windows site. What caused this scenario?

A. The Deployment Health Check has not been run.

B. The Lifecycle Management license has not been purchased.

C. Baselines have not yet been saved.

D. No computers were subscribed to the site.

Discussion 0

Correct Answer: D Vote an answer

Question 4

What is the best use of a baseline within IBM Tivoli Endpoint Manager (TEM)?

A. To deploy a set of Analyses

B. To deploy a single software package

C. To compare multiple systems

D. To maintain or level set a group of devices that need the same packages

Discussion 0

Correct Answer: D Vote an answer

Question 5

Windows Patch Tuesday occurred yesterday and the new patch fixlets are not seen in the IBM Tivoli Endpoint Manager (TEM) server. This new content has always been visible during prior patch cycles. How is the server checked to see if it is gathering content from the Internet correctly?

A. Check the gatherdb log located at Program Files\BigFix Enterprise\BES ServertGatherDBData to find information regarding the gatherDB database.

B. Content is only gathered once a week by default to conserve bandwidth. Run the force_gather command to manually kick off the process.

C. Browse to http://MyTEMServerURL:52311/rd and click the Gather Status Page link to verify that no sites are in a failed state.

D. Run the TEM diagnostic tool to ensure the Webserver component is running. This component is responsible for all Web-based connectivity.

Discussion 0

Correct Answer: C Vote an answer

Question 6

Which device would be the best candidate for a relay?

A. A laptop running Windows 7 used by a traveling salesperson with 45 GB of free disk space

B. An administrative assistant's desktop running Windows XP that is powered on at 7:00 AM and powered off at 6:00 PM with 5 GB of free disk space

C. A file and print server running SUSE 10 with 1 GB of free disk space

D. A file server running Windows 2008 R2 with 100 GB of free disk space

Discussion 0

Correct Answer: D Vote an answer

Question 7

Additional relays are to be added to an IBM Tivoli Endpoint Manager deployment. What should be verified before running the task to install the relay service?

A. Pause the BES Client service before deploying the BES Support task to install the relay in order to prevent corruption of the client

B. Verify that the relays.dat file has been edited with the new relays fully qualified domain name

C. Ensure the relay is located in the correct location or subnet by confirming the clients it will serve are at least 9 to 12 hops away

D. Verify the selected computers to become relays are normally available 24x7 and have sufficient free disk space

Discussion 0

Correct Answer: A Vote an answer

Question 8

The IT operations team wants to install IBM Tivoli Endpoint Manager (TEM) in a network where proxy Internet access is required. The proxy requires a non-Windows credential to be entered each time the Internet is accessed. Where is this registry key set: [HKEY_LOCAL_MACHINE\SOFTWARE\BigFix\Enterprise ServertGatherService]?

A. On the Top Level Relay

B. On the Internet DMZ relay

C. On a client with direct Internet access

D. On the TEM server

Discussion 0

Correct Answer: D Vote an answer

Question 9

An action is issued from a fixlet to an IBM Tivoli Endpoint Manager (TEM) client that runs the action and reports back with Pending Restart. The action expires and two days later the system running the TEM client reboots. The source fixlet for the action becomes non-relevant on the TEM client but the action status does not update to Fixed. What is the reason for this?

A. There are communication issues between the TEM client and the main TEM server.

B. The TEM client only keeps statuses for the last 24 hours.

C. TEM clients can only update their status with respect to open actions.

D. A system reboot was not part of the action so the TEM client does not update its status with respect to it.

Discussion 0

Correct Answer: C Vote an answer

Question 10

The IT Operations team is attempting to install the IBM Tivoli Endpoint Manager (TEM) Agent on 50 MacOS X systems found with the TEM Asset Discovery tool. Within the Unmanaged Asset view in the console the administrator is right-clicking and selecting Install Tivoli Endpoint Manager client but the client is not installing. What is the problem?

A. The proper root credential must be specified in the config.xml file.

B. The sudo command must be specified in the configxml file.

C. The Install via SSH/SCP option must be set prior to deployment.

D. The Install Tivoli Endpoint Manager Client function is Windows-only.

Discussion 0

Correct Answer: D Vote an answer

IBM Assess: IBM Tivoli Endpoint Manager V8.2 Implementation - A2010-577 Exam Practice Test

Contact Us

Useful Links

Latest Updated