IBM Assessment: Virtualization Technical Support for IBM i -v1 - A4040-121 Exam Practice Test

A. POWER5+ or newer, IBM i 5.4 or newer

B. POWER5+ or newer, IBM i 6.1 or newer

C. POWER6 or newer, IBM i 6.1 or newer

D. POWER6+ or newer, IBM i 7.1 or newer

A. Open Firmware OK prompt (OPEN_FIRMWARE)

B. Diagnostic with stored boot list (DIAG_STORED)

C. Diagnostic with default boot list (DIAG_DEFAULT)

D. System Management Services (SMS)

A. Promiscuous mode

B. Link aggregation

C. Network address translation

D. Schowler routes

A. To configure vLANs on Host Ethernet Adapters

B. To allow the HMCto identifythe load source disk unit

C. To specify critical hardware elements, without which the profile cannot be loaded or run

D. To specifywhich hardware elements are available to be shared using NPIV

A. Merge the shared-processor pool to be removed into one of the other pools.
Shut down the partition by deactivating it from the HMC.
Plush the memory cache by deactivating the shared-processor pool.
Delete the shared-processor pool.

B. Create a new shared-processor pool.
Merge all three shared-pools into the new pool using Live Partition Mobility
Shut down and remove the partition definition.

C. Change the minimum processor for the partition to zero.
Shut down the partition by deactivating it from the HMC.
Delete the shared-processor pool.

D. Shut down the partition that is using the shared processor pool.
Change the maximum processing units to zero.
Assign the processor capacityto another pool.

A. In the HMC, select the VIOS partition, then select Operations - Schedule Operations - Options New. Create a new Scheduled Dynamic Reconfiguration operation to move the fibre adapter between partitions.

B. Create a script that can be called after each backup job in a partition finishes, which will move the fibre adapter to the next partition

C. In the HMC, select the host Power System, then select Operations - Schedule Operations New. Create a new Scheduled Dynamic Reconfiguration operation to move the fibre adapter between partitions.

D. Configure NPIV within VIOS, then configure each partition to use NPIV to share the tape library.

A. Use a repeating scheduled job on the HMC to move the I/O resource.

B. Use a script to be run from the partitions to access the HMC and move the I/O resource after the saves have completed.

C. Afterverifyingthe save has completed, manually move the I/O resource to the next partition profile on the HMC.

D. Schedule the activation of a different profile on the HMC to allow for "desired"resources to become "required."

A. Change the users'task role to hmcoperator.

B. Create and assign a new resource role that allows access to only the required resources.

C. In Manage Users and Tasks, check each task that is needed for this user.

D. Create and assign a new task role that allows only the required set of tasks.