H35-210_V2.5-ENU by Huawei Actual Free Exam Questions And Answers

Question 1

What are the alarm levels of U2000?

A. Fatal

B. Secondary

C. Urgent

D. Important

Discussion 0

Correct Answer: B,C,D Vote an answer

Question 2

In the UA5000 chassis with PVM as the main control board, which statement about the user board is correct?

A. If it is an ASL board, it needs to be added manually, if it is an A32 board, it is automatically discovered

B. Automatic discovery

C. Must be added manually

D. If it is an A32 board, it needs to be added manually, if it is an ASL board, it is automatically discovered

Discussion 0

Correct Answer: C Vote an answer

Question 3

Which of the following descriptions about PPPoE is incorrect?

A. SESSION-ID identifies the value of a PPPOE session

B. The entire discovery phase of PPPoE includes PADI, PADO, PADR, PADS, PADT

C. PADT can be issued by the PC or BRAS at any time during the discovery phase to terminate the PPPoE dialogue

D. The destination address of PADI is the broadcast address 0xffffffff, and the source address is the Ethernet address of the host

Discussion 0

Correct Answer: C Vote an answer

Question 4

Is the following description correct? There are no restrictions on the multicast program groups that MA5600T can configure.

A. False

B. True

Discussion 0

Correct Answer: A Vote an answer

Question 5

When the Access port of the Ethernet switch receives a packet with a tag, which of the following processing behavior is correct?

A. Receive the message and tag it with the default VAN.

B. Strip the frame's PVID Tag first, and then receive it.

C. When the VLANID is different from the default VLANID, the packet is received.

D. When the VLANID is the same as the default VLANID, the packet is received.

Discussion 0

Correct Answer: D Vote an answer

Question 6

For multiple static routes reaching the same destination, you can configure different priorities for them, so as to more flexibly apply route management policies to achieve route backup. This static routing scheme is called ?

A. Static routes are permanently published

B. Floating Static Routes

C. Static Route Load Balancing

D. Default static route

Discussion 0

Correct Answer: B Vote an answer

Question 7

During normal operation and maintenance, you can run the display ont info command to query the "Run state" of the ONT. Which of the following states shows that the ONT is online?

A. to match

B. active

C. online

D. offline

Discussion 0

Correct Answer: C Vote an answer

Question 8

Is the following description correct? In a GPON network, the ONU ID must be unique under a PON port.

A. False

B. True

Discussion 0

Correct Answer: B Vote an answer

Question 9

Which of the following commands can be used to set the terminal timeout and exit time?

A. idle-time out

B. Display board

C. system name

D. Display interface

Discussion 0

Correct Answer: A Vote an answer

Question 10

Which of the following statements about the PPP protocol is correct? (Multiple choice)

A. Support point-to-multipoint connection

B. The PPP protocol provides a standard way to transmit packets of various network layer protocols over point-to-point links.

C. PPP link control protocol LCP is not only used to establish, tear down and monitor PP data links, but also mainly negotiate link layer parameters, such as MRU and authentication mode.

D. PPP protocol runs at the network layer

Discussion 0

Correct Answer: B,C Vote an answer

Huawei HCIA-Access V2.5 - H35-210_V2.5-ENU Exam Practice Test

Contact Us

Useful Links

Latest Updated