HP Supporting Industry Standard Server Solutions - HP2-T23 Exam Practice Test

A. Trap Community

B. Write Community

C. Read Community

D. System Location

E. SNMP Alert Destination

A. Amezzanine connector

B. Version Control Agent

C. Asubnet manager

D. System Management Homepage

A. back to front

B. front to back

C. bottom to top

D. top to bottom

A. Use HP SUM to update both OAs simultaneously

B. Use HP SUM Offline to update the standby OA, restart it, and repeat the procedure on the remaining OA.

C. Use the Synchronize Firmware feature in either OA

D. Use HP Systems Insight Manager (HP SIM) to push the updates to each OA.

A. The Active Health feature in the iLO Management Engine does not monitor hardware.

B. The health driver (agent management) is the only tool for HP SIM to collect server information from the iLO Management Engine.

C. Intelligent Provisioning is one of the major features of the iLO Management Engine.

D. It is recharged continuously through a trickle charging process to protect data in a failed server for up to three or four days.

A. Any two drives can fail before data loss

B. It has two independent parity schemes

C. It provides better performance than RAID 1+0.

D. It requires six disk drives.

E. Only one drive can fail at a time in each mirror set to prevent data loss

A. SmartStart

B. HP website

C. PSP DVD

D. server image file from two months ago

A. RDIMMs operating at either 1.35V or 1.5V may be mixed in any order. The system will operate at the lower voltage.

B. Four quad-ranked LRDIMMs are supported across all memory channels. The server balances capacity automatically.

C. DIMMs of different speeds may be mixed in any order. The server will select the lowest common speed.

D. UDIMMs, RDIMMs, and LRDIMMs may be mixed in the same bank in the server if only one processor is installed.

A. Replace both memory modules in slots 1 and 2

B. Replace the system board and rerun the memory diagnostics.

C. Run the ECC memory test in the diagnostics to correct the errors

D. Replace the memory module in slot 1 because it is definitely bad

A. Replace the cache module.

B. Install the BBWC battery.

C. Check the FBWC charge.

D. Verify that the firmware level is current.