HP Servicing HP Networking Products - HP3-R95 Exam Practice Test

A. The switches include two management Ethernet port status LEDs-LINK and ACT-on their front panel.

B. For the switches, an interface module's Port LEDs are in rate mode by default.

C. For the switches, an interface module's Port LEDs are yellow in rate mode if the corresponding ports are transmitting at their highest speed.

D. The switches include an Open Application Platform (OAP) module status LED on their front panel.

E. For the switches, if the Mode LED is yellow, the interface module's Port LEDs are in duplex mode rather than rate mode.

A. You can use active and standby switchover in an upgrade even when the differences between the current version of the switch software and the new version are significant.

B. Once the SMB becomes the active main board (AMB), you must manually reboot the original AMB to enable it to begin functioning as the SMB.

C. Automatic synchronization of the AMB with the SMB is the default setting.

D. The standby main board (SMB) does not run routing protocols, process or forward packets, or calculate routes.

E. You can force a switchover by entering certain commands at the command line interface (CLI).

A. A9500 Switch Series

B. A7500 Switch Series

C. A5820 Switch Series

D. A12500 Switch Series