HP Building HPE Hybrid IT Solutions - HPE0-S56 Exam Practice Test

A. Do not allow the overall system AC current load to exceed 80% of the branch circuit AC current rating

B. Use fanout cables when connecting the server to the network for maximum electrical impedance

C. Configure the server power to a single electrical circuit in the data center

D. Use a single-phase, two-wire power receptacle with protective earth or ground (PE) to filter interference from the power grid

E. Balance the server power load between available AC supply branch circuits

A. Virtual Local Area Network (VLAN)

B. Jumbo frames

C. Remote direct memory access over Converged Ethernet (RoCE)

D. Link Aggregation and Control Protocol (LACP)

A. Connect the switch grounding cable correctly.

B. Use a power surge protector.

C. Load balance the power supplies.

D. Install the switch in a rack with rubber insulators.

A. Configure multiple user IDs or roles for the console connection

B. Use a dedicated console cable to create a dedicated management network for every user

C. Configure the management IP address on the switch and enable Telnet or SSH access

D. Connect the switch to the network by using the serial cable that ships with the switch

A. Use remote console to validate the WWNs on the MSA

B. Use remote console to check the switch port configuration

C. Use remote console to ensure correct MSA port configuration

D. Use NIC teaming utility to validate the iSCSI initiator configuration

E. Use Smart Storage Administrator (SSA) to view the STATS report on the MSA

A. IMC

B. UEFI

C. Power Advisor

D. iLO