HPE6-A40 by HP Actual Free Exam Questions And Answers

Question 1

Refer to the exhibits on the tabs.
Exhibit 1

Exhibit 2

A network engineer needs to deploy a Spectrum Analyzer (SA) and then monitor the 2.4Ghz and 5Ghz spectrum. As per the requirement, the engineer is able to convent some APs into SA temporarily, but when the engineer monitors the spectrum through the controller there are issues.
Based on the information shown in the exhibits, what is the issue?

A. The engineer cannot the a radio due to improper licensing.

B. The engineer needs to put the a radio also in spectrum mode before it can be added.

C. The engineer needs to disconnect the g radio in the current configuration and then connect the a radio.

D. The engineer cannot add the a radio in spectrum mode because this mode only supports the g radio.

Discussion 0

Correct Answer: A Vote an answer

Question 2

Refer to the exhibit.

The ap spectrum local-override command is issued at the controller CLI, as shown in the exhibit.
What happens as a result?

A. All APs in the ap-group will be in spectrum mode on the 5GHz radios.

B. All APs in the ap-group will be in spectrum mode on the 2.4GHZ and 5GHz radios.

C. The AP225-1 will be in spectrum mode on the 2.4Ghz radio.

D. The AP225-1 will be in spectrum mode on the 5Ghz radio.

Discussion 0

Correct Answer: B Vote an answer

Question 3

A network engineer utilizes VLAN pool technology to solve the lack of a large network subnet a big company; However many wireless users report that they lose communication with the network when they move to different locations on the same floor. The users state they move to disconnect and reconnect to the Wi-Fi again to communicate with the network. The engineer notices that the client reams between two controllers and gets a different subnet.
How can the engineer correct this issue?

A. Use hash mode to deploy the VLAN pool

B. Enable IP mobility on the controller

C. use even mode to deploy the VLAN pool

D. Add IP addresses to the DHCP pool

Discussion 0

Correct Answer: C Vote an answer

Question 4

Refer to the exhibit.

A network engineer designs WLAN roaming for a company that has these requirements.
* Only employees are allowed to roam.
* Employees are allowed to roam from Campus 1 to HQ and from Campus 2 to HQ.
* Employees are not allowed to roam between Campus 1 and Campus 2.
What is the recommended roaming configuration to meet these requirements?

A. Enable IP Mobility in the virtual-ap profile only for the Employee SSID.
Create two mobility domains with Domain-1 active in Campus 1 and HQ, and Domain-2 active in HQ and Campus 2.

B. Enable IP Mobility in the SSID profile only for the Employee SSID.
Create two mobility domains with Domain-1 active in Campus 1 and HQ, and Domain-2 active in HQ and Campus 2.

C. Enable IP Mobility in the virtual-ap only for the Employee SSID.
Create two mobility domains with Domain-1 active in Campus 1 and Campus 2, and Domain-2 active in HQ.

D. Enable IP Mobility in the SSID profile only for the Employee SSID.
Create two mobility domains with Domain-1 active in Campus 1 and HQ, and Domain-2 active in Campus 2.

Discussion 0

Correct Answer: D Vote an answer

Question 5

Refer to the exhibit:

A customer configures three different SSIDs with three different forwarding modes on a Remote AP (RAP-B) Client A1 connects to the Family SSID.
Which is in bridge-mode, Client A2 connects to the Enterprise 802.1X SSID, which is in split-tunnel mode.
Client A3 connects to the Voice PSK SSID, which is in tunnel mode.
In which location is the 802.11 encryption terminated and the traffic decrypted for Clients A1, A2, and A3?

A. Client A1 traffic is at C: Client A2 D: Client A3 is at B.

B. Client A1 traffic is at B: Client A2 B: Client A3 is at D.

C. Client A1 traffic is at B: Client A2 D: Client A3 is at D.

D. Client A1 traffic is at C: Client A2 B: Client A3 is at B.

Discussion 0

Correct Answer: C Vote an answer

Question 6

How is an AP redirected to a local controller after the DNS resolution returns the master controller IP address?

A. The AP provides the AP name to the controller from the environment variable, and the master controller returns the AP Group. The AP uses the controller-ip attribute that is set in AP provisioning.

B. The master controller provides the AP Group based upon the AP name, and the AP uses the AP Group controller-ip attribute.

C. The master controller provides the LMS-IP from the AP Group, and the AP uses the LMS-IP that is set in the AP Provisioning based upon the AP Group.

D. The master controller provides the AP Group to the AP, and the AP uses the LMS-IP from the AP-System profiles configured for the AP Group.

Discussion 0

Correct Answer: A Vote an answer

HP Aruba Certified Mobility Expert 6.4 Written - HPE6-A40 Exam Practice Test

Contact Us

Useful Links

Latest Updated