Motorola Solutions Deploy WLAN Solutions - MSC-122 Exam Practice Test
Which of the following is the single biggest security vulnerability evident in the image below?


Correct Answer: D
Vote an answer
If you perform a manual setup of an RFS controller, it is easy to inadvertently miss some important configuration parameters. If not configured, which of the following items will result in non-functioning AP radios?
Correct Answer: B
Vote an answer
Which of the following types of AP adoption require that DHCP services be enabled on the AP's native VLAN?
Correct Answer: D
Vote an answer
Which of the following APs does not support adaptive mode?
Correct Answer: D
Vote an answer
Following the installation of an RFS4000 controller with AP650 APs you use a popular WLAN discovery application to capture and display traffic to and from one of the APs. You notice that the majority of the transmitted frames are being sent at a very low speed, as shown in image below, even though the 802.11n connection supports a 130 Nbps signaling rate. What is the most likely cause of this condition?


Correct Answer: C
Vote an answer
A hospital has asked you to design a wireless infrastructure that supports voice and video. Which of the following would not be included in the wireless design?
Correct Answer: C
Vote an answer
As part of the Acceptance Testing you will need to validate that the failover design of your RFS controllers is working. Your configuration is two RFS7000 controllers. You decide to check your failover status by inspecting the System Status LEDs on the primary RFS7000 controller. If your system is configured and functioning correctly what is the expected current state of the System Status 2 LED? Please use the Status exhibit at the bottom.


Correct Answer: C
Vote an answer
After completing a site survey on a new (empty) warehouse, which of the following could significantly impact your final design?
Correct Answer: B
Vote an answer
After the site survey and installation are complete, you perform a spot check to ensure performance compliance with the site survey. Which of the following should NOT be verified in this spot check?
Correct Answer: B
Vote an answer