NACE Coating Inspector Level 2 - NACE-CIP2-001 Exam Practice Test
You are the NACE Inspector on a project where a stationary floating structure is being coated and you notice a self-smoothing anti-fouling coating has been specified.
This is not a good choice because:
This is not a good choice because:
Correct Answer: B
Vote an answer
Surface preparation methods for Non-ferrous metals are:
Correct Answer: C
Vote an answer
The coating applicator has ignored a enface preparation hold point and applied coating over the surface without a sign off from you as the inspector.
Your FIRST preferred course of action is to:
Your FIRST preferred course of action is to:
Correct Answer: A
Vote an answer
In powder coatings, when the particles of powder begin to flow but are not fully liquid, they are in what stage?
Correct Answer: A
Vote an answer
The standards defining surface cleanliness achieved by centrifugal blast cleaning are:
Correct Answer: C
Vote an answer
When completing the Final Inspection report the Inspector should write the report using:
Correct Answer: A
Vote an answer
When using a destructive Paint Inspection Gauge the NACE inspector must:
Correct Answer: B
Vote an answer
You are a NACE Level 2 Coating Inspector who has just arrived on a job in progress where there is no Inspection and Test Plan (ITP). The first morning you arrive the job is behind schedule and you are asked to take DIY Film Thickness readings.
Your FIRST preferred course of action is to:
Your FIRST preferred course of action is to:
Correct Answer: D
Vote an answer
In the event of a conflict between the Product Data Sheet and the Specification:
Correct Answer: B
Vote an answer
Which surface preparation method uses a dilute acid solution to remove laitance and I roughen the concrete surface?
Correct Answer: A
Vote an answer