Citrix NetScaler 10.5 Essentials and Networking - 1Y0-351 Exam Practice Test
A NetScaler Engineer would like to encrypt the LDAP authentication traffic from a NetScaler to the internal LDAP servers.
Which type of load-balancing service should the engineer create?
Which type of load-balancing service should the engineer create?
Correct Answer: D
Vote an answer
Scenario: A NetScaler Engineer is configuring LACP (Link Aggregation Configuration Protocol) on the NetScaler. The engineer adds interface 10/3 and 10/4 to LA/1 (which already contains interfaces 10/1 and 10/2) and is configured for VLAN 500.
VLAN 100 is bound to interface 10/3 and VLAN 200 is bound to interface 10/4.
VLAN 500 is bound to channel LA/1.
Which VLAN is shown with a "show interface" command for interface 10/3?
VLAN 100 is bound to interface 10/3 and VLAN 200 is bound to interface 10/4.
VLAN 500 is bound to channel LA/1.
Which VLAN is shown with a "show interface" command for interface 10/3?
Correct Answer: B
Vote an answer
What should a NetScaler Engineer configure to create load-balancing virtual servers and services on the same VLAN with overlapping IP addresses?
Correct Answer: C
Vote an answer
Scenario: Primary NetScaler (NS1) is licensed for 10000 Maximum ICA users and 305 Access Gateway users. Secondary NetScaler (NS2) is licensed for 10000 Maximum ICA users and five Access Gateway users.
From where and which command should a network engineer run to display diagnostics on the licenses?
From where and which command should a network engineer run to display diagnostics on the licenses?
Correct Answer: B
Vote an answer
Which two parameters in the TCP buffering settings can be controlled by a network engineer? (Choose two.)
Correct Answer: A,D
Vote an answer
When a network engineer logs onto a new NetScaler device in the London datacenter, data output indicates that the device is NOT configured for the local time.
How can the network engineer synchronize the correct time with an NTP server in the local data center?
How can the network engineer synchronize the correct time with an NTP server in the local data center?
Correct Answer: C
Vote an answer
In order to configure integrated cache, a NetScaler Engineer would need to reboot the NetScaler when the integrated caching feature is __________ and cache memory limit is set to __________. (Choose the correct set of options to complete the sentence.)
Correct Answer: D
Vote an answer
Scenario: A NetScaler Engineer is configuring a NetScaler that has three interfaces. The first interface is connected to the internal network, the second interface is connected to the DMZ1-network, and the third interface is connected to the DMZ2-network.
DMZ1 and DMZ2 networks are behind different firewalls, and both firewalls are sending traffic through network address translation (NAT) to the DMZ networks.
The default route is to the gateway on the DMZ1-network.
DMZ1: 10.10.10.0/24 (Gateway: 10.10.10.1)
DMZ2: 10.20.20.0/24 (Gateway: 10.20.20.1)
Internal: 192.168.0.0/24 (Gateway: 192.168.0.1)
Internet traffic reaches the virtual servers located in DMZ1 but NOT the virtual servers located in DMZ2.
Which policy-based route (PBR) would resolve the issue?
DMZ1 and DMZ2 networks are behind different firewalls, and both firewalls are sending traffic through network address translation (NAT) to the DMZ networks.
The default route is to the gateway on the DMZ1-network.
DMZ1: 10.10.10.0/24 (Gateway: 10.10.10.1)
DMZ2: 10.20.20.0/24 (Gateway: 10.20.20.1)
Internal: 192.168.0.0/24 (Gateway: 192.168.0.1)
Internet traffic reaches the virtual servers located in DMZ1 but NOT the virtual servers located in DMZ2.
Which policy-based route (PBR) would resolve the issue?
Correct Answer: D
Vote an answer
Scenario: A NetScaler Engineer has a high-availability (HA) pair of NetScaler MPX devices (NS1 and NS2) connected on interfaces 0/1, 1/1 and 1/2. NS1 is currently the primary unit.
Fail-safe mode is NOT enabled. High-availability monitor is enabled on all the connected interfaces. The engineer sees the following line in the output of his "show node" command from the command-line interface:
Interfaces on which heartbeats are not seen: 1/1 1/2
Interfaces causing Partial Failure: None
What will happen if the 0/1 interface fails?
Fail-safe mode is NOT enabled. High-availability monitor is enabled on all the connected interfaces. The engineer sees the following line in the output of his "show node" command from the command-line interface:
Interfaces on which heartbeats are not seen: 1/1 1/2
Interfaces causing Partial Failure: None
What will happen if the 0/1 interface fails?
Correct Answer: A
Vote an answer
Scenario: A NetScaler Engineer recently enabled the HTTP Compression feature. In reviewing the HTTP compression statistics, the engineer notices that content from all HTTP virtual servers created prior to enabling the compression feature is NOT being compressed.
What should the engineer do to allow compression for any pre-existing HTTP virtual servers?
What should the engineer do to allow compression for any pre-existing HTTP virtual servers?
Correct Answer: C
Vote an answer
The security department just conducted a penetration test on the published virtual servers and all of the SSL virtual servers returned the result "Allowed changing to weak certificate standard" in the report.
The reason for this result could be that the network engineer who configured the virtual servers forgot to __________. (Choose the correct option to complete the sentence.)
The reason for this result could be that the network engineer who configured the virtual servers forgot to __________. (Choose the correct option to complete the sentence.)
Correct Answer: A
Vote an answer
On which two types of virtual servers is the SOURCEIP persistence type supported? (Choose two.)
Correct Answer: A,D
Vote an answer