Cisco CCIE Wireless Written - 400-351 Exam Practice Test
RX-SOP is configured for the 2.4GHz and 5 GHz radios with the value set as Low Threshold.
Which two values represent the threshold values for each band? (Choose two.)
Which two values represent the threshold values for each band? (Choose two.)
Correct Answer: A,B
Vote an answer
Which statement is true for Cisco Virtual Wireless LAN Controllers?
Correct Answer: B
Vote an answer
Which port does cisco JSE use by default to send RADIUS CoA messages to the Cisco WLC?
Correct Answer: D
Vote an answer
Which two descriptions of the encoding formats supported by RESTCONF and NETCONF are true? (Choose two.)
Correct Answer: D,F
Vote an answer
You have recently configured an mDNS service gateway on your company controller. Wireless clients connected to the corporate SSID "ssid_dot1X" are put in VLAN 10, and they can discover an AppleTV connected over wireless to SSID "ssid_bonjour", which is mapped to VLAN 20.
However, they cannot discover a wired printer connected in VLAN 30. Which two reasons for this issue are most likely? (Choose two.)
However, they cannot discover a wired printer connected in VLAN 30. Which two reasons for this issue are most likely? (Choose two.)
Correct Answer: C,D
Vote an answer
Which parameter is a functionality of Micro segmentation in the Data Center?
Correct Answer: D
Vote an answer
Users complain about intermittent wireless connectivity issues. You see the following message on your Cisco WCS, corresponding the time the connectivity issues occurred.
AP 'building-1-entrance', interface '802.11b/g' on Controller '10.1.1.2'. Noise threshold violated.
What do you do?
AP 'building-1-entrance', interface '802.11b/g' on Controller '10.1.1.2'. Noise threshold violated.
What do you do?
Correct Answer: B
Vote an answer
Refer to the exhibit which syslog logging facility and severity level is enabled on this AP?
Correct Answer: D
Vote an answer
You have recently upgraded your autonomous AP to run the latest Cisco IOS available version, and configured it to broadcast SSID "Test" on its 5GHz radio. You are using these basic data rates; 6 Mbps, 12 Mbps and 24 Mbps. Which statement is true?
Correct Answer: D
Vote an answer
Refer the exhibit. A Wireless user has roamed tram an AP connected to MA-l to an AP connected to MA?:S. The traffic flow for the user before the roam is shown. Which option shows the traffic flow for the user after roam,considering default sticky anchoring is disabled on the WLAN, and WLAN to VLAN mapping and roaming domain IDs are identical on both sides?
Correct Answer: C
Vote an answer