Aruba Certified Campus Access Mobility Expert Written Exam: HPE7-A07 Exam Premium File as PDF & Test Engine

Your customer recently decided to build a new wireless network based on AOS-10. The following legacy settings still exist:
* The DHCP server still sends option 60 "ArubaInstantAP" and option 43 including the IP address of the AirWave server in the ZTP VLAN.
* The DNS server has an entry for "aruba-airwave" pointing to the AirWave server.
The customer purchased new AP-655 access points and HPE Aruba Networking Central subscriptions.
Each AP is assigned to the "ACX-Group" in the Device Pre-provisioning section of Central, and the external firewall allows HTTPS traffic between APs and the Internet.
What will happen when the new factory default APs are connected to the customer's network for the first time?

• A. The new APs will contact the IP address of AirWave from DHCP option 43
• B. The new APs will contact the cloud and get the "ACX-Group" configuration in HPE Aruba Networking Central
• C. The new APs will contact the cloud and will be pointed to the IP address of AirWave
• D. The new APs will contact the IP address of AirWave learned from the DNS entry "aruba-airwave"

Based on the output above, what is required to associate the GBP policy with a user role?

• A. Update the port-access GBP policies to reference the EMPLOYEE role
• B. Update the entries in the class maps to reference the EMPLOYEE role
• C. Associate the port-access role to the GBP role using the role ID
• D. Configure a user role called GBP-EMPLOYEE instead of EMPLOYEE

The ACME company has an AOS-CX 6200 VSF switch slack with an uplink over subscription ratio of 9.6:1.
They have indicated that their low-priority TCP traffic has been flagged with a DSCP marking coloring them yellow.
Refer to the exhibit.


They are considering adding two more nodes to the stack without adding any additional uplinks due to existing wiring constraints. One of their architects has suggested adding the following configuration:

What would be the impact of applying the acmethreshold profile as shown? (Select two.)

• A. Only VoIP packets egressing queue 5 on LAG1 will likely be protected from uplink over-utilization.
• B. VoIP packets egressing any queue on LAG1 will more likely be protected from uplink over-utilization
• C. All upper-layer protocol traffic egressing LAG1 will be subject to drop probability.
• D. All TCP traffic egressing LAG1 wail be subject to drop probability
• E. Yellow-flagged TCP traffic egressing LAG1 will be subject to drop probability

A customer wan a gateway connected to a device on gigabitethernet 0/0/3 configures an Asset ID TLV on the device for inventory management.
Exhibit.

The customer mentions me Asset ID is not shown What is causing the issue?

• A. MTU size is too small.
• B. LLPD-MED needs to be enabled.
• C. LLDP TX is not enabled.
• D. Unknown TLVs cannot be displayed.