Motorola Solutions Design Point (PTP and PMP) Solutions - MSC-111 Exam Practice Test
When using the FTP600 product what is the default antenna polarization?
Correct Answer: B
Vote an answer
A problem microwave system planners face is the fact that the ground between two far points may not be flat and Line of Sight (LoS) may be lost after as little as 10 miles if not taken into account. What is this called?
Correct Answer: D
Vote an answer
A customer with an existing Motorola PMP deployment has installed the same type equipment in another country. The customer is concerned as the coverage pattern, using the same antennas, is significantly different at the new location. Given the options below, what is MOST likely the cause?
Correct Answer: D
Vote an answer
When using Broadband Planner to model a PMP link, the amount of attenuation through a given obstruction type can be changed by modifying the:
Correct Answer: D
Vote an answer
Which FTP product has T1/El connections directly on the outdoor unit?
Correct Answer: B
Vote an answer
Oceanside Information
The community of Oceanside is interested in obtaining a broadband access solution to all of the homes in the neighborhood. There is no fiber access in the neighborhood; however there is fiber near the entrance to the neighborhood on Highway A1A. The neighborhood association has requested that the proposal not have any tear-up of the existing roads.
The anticipated service area is approximately 1/2 x 1/3 miles.
Click on the Exhibit button to access the "Oceanside Map" and the "RFP Requirements"



The customer requirement calls for an over subscription rate of 20%, this supports which of the following statements?
The community of Oceanside is interested in obtaining a broadband access solution to all of the homes in the neighborhood. There is no fiber access in the neighborhood; however there is fiber near the entrance to the neighborhood on Highway A1A. The neighborhood association has requested that the proposal not have any tear-up of the existing roads.
The anticipated service area is approximately 1/2 x 1/3 miles.
Click on the Exhibit button to access the "Oceanside Map" and the "RFP Requirements"



The customer requirement calls for an over subscription rate of 20%, this supports which of the following statements?
Correct Answer: A
Vote an answer
What are two relevant considerations when determining the coverage from an AP cluster
(select TWO)?
(select TWO)?
Correct Answer: A,B
Vote an answer
The amount of MAC addresses to Ethernet Port mappings in a switch is finite. What happens when the available mappings in these lookup tables are exhausted?
Correct Answer: C
Vote an answer