[Aug 22, 2022] Fully Updated NCS Professional (NCS-Core) Certification Sample Questions
Latest Nutanix NCS-Core Real Exam Dumps PDF
What is the purpose of the Nutanix NCS-Core Certification Exam
The purpose of the Nutanix NCS-Core Certification exam is to test whether a candidate has a comprehensive understanding of the topics they will be responsible for configuring and managing. It ensures that candidates can perform tasks efficiently and quickly, protecting critical data stored on the Nutanix platform. Attempting the exam will show your dedication to the science of science and technology. Nutanix NCS-Core Dumps will give you the confidence to pass the exam because it is designed with exact questions, which are equivalent to the actual NCS-100 test.
The Importance of Nutanix NCS-Core Certification
The Nutanix NCS-Core Certification is important to the career of a Nutanix engineer. It demonstrates a candidate's ability to successfully configure and troubleshoot a Nutanix cluster. It also proves the candidate has a level of knowledge in several core topics, which may be tested on the NCE exam. Nutanix NCS-Core Dumps is an exam that measures a candidate's knowledge and ability to answer technical questions based on the IDM. Those who attempt the certification can establish a strong career path and gain new opportunities.
NEW QUESTION 24
Refer to the exhibits.
A consultant is trying to test port failover on the node shown in the first exhibit. A continuous ping test is performed to the host. The consultant shuts down one of the links, after which the host ping request times out.
The consultant tries to troubleshoot the issue with the customer and sees the information shown in the second exhibit on their Cisco Switches:
What is causing the issue?
- A. The wrong VLAN is tagged on the host.
- B. PortFast is not enabled on the port connected to the host.
- C. Bad SPF+ cables are on the active interface.
- D. There is a Native VLAN mismatch on the switchport.
Answer: D
NEW QUESTION 25
To prepare for a new Nutanix installation, a consultant downloads the Foundation VM, imports the VM to their Desktop Virtualization Solution, and powers on the VM. The IPv4 static address on the host workstation and the Foundation VM have been configured, but pings between them fail.
Which two troubleshooting steps should the consultant perform? (Choose two.)
- A. Confirm the IP addresses and subnet masks are correct.
- B. Verify the virtual NIC in the Foundation VM is bound to the correct physical Host adapter.
- C. Verify the virtual NIC in the Foundation VM is bound to the correct wireless network adapter.
- D. Remove and re-import the Foundation VM to ensure the virtual NIC is set to Host-Only.
Answer: A,B
NEW QUESTION 26
An administrator has a 32-node hybrid cluster with CPU, RAM and storage utilization of 80%. A database VM is configured with VM Flash.
What is causing this IO latency?
- A. VM Flash Mode reduces SSD tier capacity for VMs.
- B. Curator scans causes by ILM constantly moving data.
- C. Controller VM is experiencing high CPU ready time.
- D. Database VM is experiencing high CPU ready time.
Answer: C
NEW QUESTION 27
A customer has a four-node cluster and is using Volume Groups toprovide storage services to a SQL cluster.
In the event of a CVM failure in the cluster, what is the expected IO path of the volume group's iSCSI targets?
- A. vDisk directed to failed CVM are redirected to another CVM and automatically reconnect
- B. vDisk directed to CVM that failed to disconnect and will not reconnect without manual intervention
- C. vDisk directed at failed CVM will disconnect and reconnect when thefailed CVM comes back online
- D. vDisk directed at failure CVM are redirected to Data Services IP until CVM is reconnected
Answer: A
NEW QUESTION 28
An existing Nutanix customer has several clusters in production and is adding a new cluster. The customer wants to create an AHV cluster that has already been racked and powered on remotely, with the factory image, using Prism Central.
Which step should the consultant take next?
- A. Build the cluster with the Foundation VM.
- B. Build the cluster with Foundation Central.
- C. Bare metal image the nodes with the Foundation VM.
- D. Build the cluster with the Foundation Applet
Answer: D
NEW QUESTION 29
A customer wants to run SAP HANA on a Nutanix cluster with the following characteristics:
* AHV nodes
* SAP HANA version 2
* Production database files
Which configuration should be recommended to the customer?
- A. Do not enable compression, deduplication. or erasure coding on the storage container
- B. Plate the SAP HANA Database on the same socket as CVM
- C. Enable only compression for the container that contains the Production database
- D. Start with a cluster containing three or more nodes
Answer: A
Explanation:
Explanation
Ref:
NEW QUESTION 30
A customer wants to use NIC teaming on an ESXi host using a vSphere Standard Switch configured with the Route based on physical NIC load load balancing option. The customer does not see the option when editing the Teaming and Failover settings for the switch.
How should the consultant resolve this issue?
- A. Add a vSphere Distributed Switch
- B. Add another physical NIC to the team.
- C. Change the load balancing option on the switch.
- D. Install a vCenter server to manage the switch
Answer: A
NEW QUESTION 31
Refer to the exhibit.
An administrator creates a security policy that isolates their financial application from accessing the Internet When viewing the policy in Prism Central, several connections from the application are outbound to the Internet.
What is causing this issue with the policy?
- A. The 0.0.0.0 address was not specified in the outbound rule.
- B. The blockedconnections are illustrated for information only.
- C. The Activate box was not checked in the rule, so it is not enforcing.
- D. The policy has been left in monitor mode instead of enforcing mode.
Answer: D
Explanation:
Explanation
https://portal.nutanix.com/page/documents/details?targetId=Prism-Central-Guide-Prism-v510:mul-security-polic
NEW QUESTION 32
A consultant is unable to install virtualization software on a laptop.
Which two versions of Foundation can be used to resolve this issue? (Choose two.)
- A. Foundation Central
- B. Foundation Applet
- C. Foundation Portable
- D. Foundation VM
Answer: B,C
NEW QUESTION 33
An administrator has a custom backup application that requires a 2TB disk and runs in Windows. Throughput is considerably lower than expected.
The application was installed on a VM with the following configuration:
* Four vCPUs with one core/vCPU
* 4GB of Memory
* One 50GB vDisk for the Windows installation
* One 2TB vDisk for the application
What is the recommended configuration change to improve throughput?
- A. Span the 2TB disk across four vDisks
- B. Increase the vCPUs assigned to the VM
- C. Increase the number of cores per vCPU
- D. Add 4GB of memory to the VM
Answer: A
NEW QUESTION 34
A customer has an ESXi Cluster with two 10GbE NICs on each node with the following requirements:
* Solution must follow Nutanix Best Practices
* Network configuration should be redundant
* A vSphere Standard Switch must be utilized
Which load balancing method should be used?
- A. Route based on source MAC hash
- B. Route based on physical NIC load
- C. Route based on IP hash
- D. Route based on originating port ID
Answer: D
NEW QUESTION 35
An administrator has two clusters: Site A and Site B.
Async DR is configured between the clusters as follows:
* Site A is the Primary Site
* Site B is the Secondary inactive Site, no VMs running
* Site A is fully in Production
* Site B used as Backup/Disaster Recovery
The customer wants to perform a planned failover between the sites.
How should the administrator accomplish this?
- A. Click Activate on the Secondary site within the Data Protection Dashboard
- B. Choose Migrate on the Secondary site within the Data Protection Dashboard
- C. Click Activate on the Secondary site and run deactive NCLI command on Primary site
- D. Choose Migrate on the Primary sitewithin the Data Protection Dashboard
Answer: D
Explanation:
Explanation
Ref:https://portal.nutanix.com/page/documents/details?targetId=Web-Console-Guide-Prism-v510:wc-protection-
NEW QUESTION 36
A consultant is planning an installation and needs to collect configuration items to be used during the install.
The data needed from the customer are IP addresses, Gateway, DNS servers, and NTP Servers.
Which Cluster Deployment document must be completed with the customer?
- A. Project Plan
- B. Technical Checklist
- C. Questionnaire
- D. Operations Guide
Answer: B
NEW QUESTION 37
A guest VM is reported to have poor storage performance. It has an I/O profile of 80%read. 20% write, and the HDDs form more than 50% of the read source.
What should an administrator do to resolve this issue?
- A. Increase the write cache
- B. Increase the OPLOG
- C. Increase SSD capacity
- D. Use HDDs with higher RPM
Answer: C
Explanation:
Explanation
Ref:
https://portal.nutanix.com/page/documents/solutions/details?targetId=BP-2126-SAS-on-Nutanix:BP-2126-SAS-o
NEW QUESTION 38
Refer to the exhibit.
An administrator receive the warningmassages shown in the exhibit while validating cluster conversion from EXSi to AHV.
What should the administrator do to address this warning in v Center Server?
- A. Keep active adapters od different speeds as active standby
- B. Remove the standby adapters under Teaming and Failover.
- C. Remove adapters that are active but not homogeneous.
- D. Keep homogeneous adapter as active and standby
Answer: D
NEW QUESTION 39
A three-node cluster has a Nutanix Files instance with three FSVMs.
What happens after a node failure?
- A. The affected FSVM willbe restarted on another node.
- B. The affected FSVM will not be restarted on another node due to its VM-to-VM anti-affinity settings.
- C. The affected FSVM will not be restarted on another node due to its agent VM setting.
- D. The affected FSVMwill get live-migrated to another node.
Answer: A
Explanation:
Explanation
Ref:https://portal.nutanix.com/page/documents/details?targetId=Files-v3_6:fil-files-high-availability-c.html
NEW QUESTION 40
......
Difficulty in writing Nutanix NCS-Core Certification Exam:
The writing process for this exam is quite difficult because it covers not only installation and configuration of the NVP, but also the network, storage, user management, system compatibility, capacity planning of Nutanix systems, high availability of Nutanix systems, data management, encryption management of data at rest in Nutanix systems. It also covers best practices related to performance tuning. This section also includes how to create virtual machines with Nutanix systems. Nutanix NCS-Core Dumps will be very useful for you to pass the exam and get the certification. Achieve maximum performance from Nutanix systems when designing and creating these virtual machines.
Nutanix NCS-Core Dumps - Secret To Pass in First Attempt: https://www.fast2test.com/NCS-Core-premium-file.html
NCS-Core Practice Test Questions Updated 195 Questions: https://drive.google.com/open?id=11lrxbRAp8uPPFOkxyyedvLTPkcrnAb2q