Fast2test NCM-MCI5.15 dumps & Nutanix Certified Master Sure Practice with 108 Questions [Q40-Q55]

Fast2test NCM-MCI5.15 dumps & Nutanix Certified Master Sure Practice with 108 Questions

New NCM-MCI5.15 Exam Questions| Real NCM-MCI5.15 Dumps

NEW QUESTION 40
An administrator is deploying a three-tier application on a Nutanix Enterprise Cloud consisting of web, application, and database VMs. Traffic between the servers must be limited to specific services/ports. There is an application layer firewall VM deployed on one host in the cluster.
In which way should the administrator meet this requirement?

A. Separate the web. application and database VMs on to dedicated VLANs
B. Configure a security policy and service chain redirecting the server traffic through the firewall
C. Categorize the VMs in Prism Central and utilize Flow to set a security policy
D. Create a network for each type of VM, and use policy-based routing to control the traffic flow

Answer: C

NEW QUESTION 41
An administrator protected a DB VM running on a Nutanix cluster with NearSync Replication, which schedules to repeat every 15 minutes to a second site. The daily change rate is low. During nightly backups, the replication window is missed due to write volume.
Which two options describe the expected behavior? (Choose two.)

A. NearSync stops working and fails over to the remote site.
B. The system continuously tries to get to the NearSync schedule.
C. Protection Domain transitions back to the hourly schedule.
D. The Administrator needs to re-enable it manually.

Answer: A,B

NEW QUESTION 42
An administrator is planning to deploy a Nutanix cluster to support a few high-performance VMs. This deployment will have the following considerations:
* Individual VMs will likely generate network throughputs in the range of 90-100Mbps
* Due to the configuration of the VMs, it is unlikely that a node will host more than one or two of them at a time
* Individual VMs will communicate with only a few (one or two) remote hosts at a time
* Multicast will not be used in the environment
* The hosts are connected via two 1GbE network connections
How should the administrator configure the network bonds to meet this requirement while maintaining the simplest switch configuration?

A. Configure bond0 as active-backup
B. Configure bond0 as balance-lacp
C. Configure bond0 as balance-tcp
D. Configure bond0 as balance-sib

Answer: D

Explanation:
Ref: https://portal.nutanix.com/page/documents/solutions/details?targetId=BP-2071-AHV-Networking:top_ahv_networking_best_practices.html

NEW QUESTION 43
Refer to the exhibit.

A Nutanix host is connected as shown in the exhibit with br0-up set to active/backup. Physical Switch 1 experiences a power outage causing br0-up to failover to using eth2. The CVM and host become inaccessible. User VMs restart on other hosts in the cluster, which causes a disruption to those VMs.
Which configuration issue likely caused this outage?

A. Bridge br0-up should be configured to use balance-tcp rather than active/backup.
B. The user VMs only have one NIC
C. The CVM should have eth1 connected to the OVS.
D. The upstream port for eth2 is missing a VLAN.

Answer: D

Explanation:
Ref: https://portal.nutanix.com/page/documents/solutions/details?targetId=BP-2071-AHV-Networking:top_ahv_networking_best_practices.html

NEW QUESTION 44
An administrator receives reports about a Nutanix environment. The investigation finds the following;
* VMs are experiencing very high latency
* Each node is equipped with a single SSD, utilized at 95%
* Each node is equipped with three HDDs, utilized at 40%
Why are the guest VMs experiencing high latency?

A. CVMs are overwhelmed by disk balancing operations.
B. VMs are unable to perform write operations.
C. All VM write operations are going to HDD.
D. All VM read operations are coming from HDD.

Answer: D

Explanation:
Ref: https://next.nutanix.com/prism-infrastructure-management-26/disk-space-usage-high-alert-in-prism-38199

NEW QUESTION 45
An administrator needs to maximize storage potential in a six-node cluster. The container is configured with the following:
Post-process compression
Capacity deduplication
What should the administrator configure to increase space savings?

A. Erasure coding
B. Reserve capacity
C. Cache dedupe
D. Inline compression

Answer: A

NEW QUESTION 46
An administrator needs to replace the self-signed certificate on a cluster. Which two requirements must be met as part of the process? (Choose two.)

A. The imported files for the custom certificate must be PEM encoded.
B. The signed, intermediate and root certificates are chained.
C. The cluster administrator must restart the interface gateway.
D. The existing certificate must be deleted prior to replacement.

Answer: A,B

Explanation:
Ref: https://portal.nutanix.com/page/documents/details?targetId=Prism-Central-Guide-Prism-v55:mul-security-ssl-certificate-pc-t.html

NEW QUESTION 47
A new Nutanix cluster is ready for production on a remote site with no IT staff. Changes to the infrastructure will cost money and probably cause a cluster stop. The administrator needs to perform a health check on the environment that should include:
* Network connectivity checks
* Network performance status
* Storage performance status
Which tool should be used to perform this test?

A. X-Ray
B. diagnostic, py
C. clurator_cli
D. NCC

Answer: D

NEW QUESTION 48
In a Nutanix cluster, a Protection Domain contains 50 entities that are replicated to a remote Single Node Replication Target.
The current schedule configuration is as follows:
* Repeat every 6 hours
* Local Retention Policy 1
* Remote Retention Policy 8
* Starting time 12 am
At 8 am on Monday, the administrator discovers that a protected VM is corrupted. The latest good state was Sunday 2 pm. The administrator needs to maintain current protection.
Which strategy should the administrator use to meet these requirements?

A. From the Remote site, activate the Protection Domain, then re-protect the entity.
B. From the Remote site, restore the VM from the local snapshot by selecting the correct snapshot
C. From the local site, restore the VM from the local snapshot by selecting the correct snapshot.
D. From the local site, retrieve the correct remote snapshot, then restore the VM locally.

Answer: D

NEW QUESTION 49
A customer needs a DR solution designed around the following requirements:
* There are 8 ms of latency between Sites A and B
* The administrator needs the shortest RPO/RTO possible
* Application consistent snapshots are required
* Use of Nutanix VSS
Which Data Protection Method should be used?

A. Near Sync
B. Cloud Connect
C. Metro Availability
D. Async

Answer: A

Explanation:
Ref: https://portal.nutanix.com/page/documents/details?targetId=Prism-Element-Data-Protection-Guide-v5_18:wc-dr-application-consistent-snapshots-wc-r.html

NEW QUESTION 50
Refer to the exhibit.
An administrator logged into Prism Element, notices the following in the home dashboard, and showing the exhibit.
Which action should the administrator take next?

A. Check the hardware page for disk failures
B. Troubleshoot the zookeeper server issue
C. Configure the fqdn for the hosts indicated
D. Re-run NCC specifying data_resiliency_check

Answer: D

NEW QUESTION 51
An administrator needs to make sure an RF2 cluster can survive a complete rack failure without negatively effecting workload performance. The current cluster configuration consists of the following:
* 30 nodes: distributed 10 nodes per rack across three 42U rack
* Each nodes is configured with 40TB usable storage all flash (Cluster Total 1.2 PB Usable)
* Current cluster utilization is 900TB storage
Which configuration changes should be made to make sure that the cluster meets the requirements?

A. Expanse the cluster by adding 8 nodes to a new 42U rack
B. Expanse the cluster by adding 3 additional nodes per rack, 9 nodes total.
C. Expanse the cluster by adding 2 additional nodes per rack, 6 nodes total.
D. Expanse the cluster by adding 9 nodes to a new 42U rack

Answer: B

Explanation:

NEW QUESTION 52
An administrator has two clusters: Site A and Site B.
Async DR is configured between the clusters as follows:
* Site A is the Primary Site
* Site B is the Secondary inactive Site, no VMs running
* Site A is fully in Production
* Site B used as Backup/Disaster Recovery
The customer wants to perform a planned failover between the sites.
How should the administrator accomplish this?

A. Choose Migrate on the Secondary site within the Data Protection Dashboard
B. Click Activate on the Secondary site and run deactive NCLI command on Primary site
C. Click Activate on the Secondary site within the Data Protection Dashboard
D. Choose Migrate on the Primary site within the Data Protection Dashboard

Answer: D

Explanation:
Ref: https://portal.nutanix.com/page/documents/details?targetId=Web-Console-Guide-Prism-v510:wc-protection-domain-failover-wc-t.html

NEW QUESTION 53
A three-node cluster has a Nutanix Files instance with three FSVMs.
What happens after a node failure?

A. The affected FSVM will get live-migrated to another node.
B. The affected FSVM will be restarted on another node.
C. The affected FSVM will not be restarted on another node due to its agent VM setting.
D. The affected FSVM will not be restarted on another node due to its VM-to-VM anti-affinity settings.

Answer: B

Explanation:
Ref: https://portal.nutanix.com/page/documents/details?targetId=Files-v3_6:fil-files-high-availability-c.html

NEW QUESTION 54
Microsegmentation was recently enabled in a Nutanix environment. The administrator wants to leverage Prism Central to create a policy that will block all traffic, regardless of direction, between two groups of VMs identified by their category.
Which policy should be used to meet this requirement?