Sep-2021 Latest Fast2test NS0-183 Exam Dumps with PDF and Exam Engine Free Updated Today!
Following are some new NS0-183 Real Exam Questions!
NEW QUESTION 80
After properly cabling the NetApp CN1610 cluster switches, you see that joining the second node to a cluster fails because the node is not able to communicate with the other node.
In this scenario, what is causing this problem?
- A. The NTP server is not set.
- B. CN1610 is unsupported in newer ONTAP versions.
- C. The RCF file is not loaded properly.
- D. The cluster switches must be Cisco for more than two nodes in a cluster.
Answer: C
NEW QUESTION 81
Click the Exhibit button.
A customer has two Cisco 40GbE data switches. They want to connect the switches to an AFF A400 HA pair.
The switches and the AFF A400 are approximately seven meters apart.
Referring to the exhibit, which two supported actions would allow you to accomplish this task? (Choose two.)
- A. Install 10 meter NetApp supported copper cables.
- B. Change the requirement for optical cables.
- C. Relocate the switches or the AFF A400 so that the distance is less than five meters.
- D. Change the requirement for Ethernet cables.
Answer: A,D
NEW QUESTION 82
Click the Exhibit button.
You are installing a new FAS cluster. The management network must be on tagged VLAN 11 for remote administration by a service provider.
Referring to the exhibit, which two ports will allow service provider access to both cluster and node management LIFs? (Choose two.)
- A. e0M
- B. e0M-11
- C. e0a-11
- D. e0b-11
Answer: A,B
NEW QUESTION 83
Your customer wants a newly installed AFF C190 cluster to send SNMP notifications to a trap host called OVERWATCH01.
In this scenario, which two statements are correct? (Choose two.)
- A. Configure DNS on the cluster.
- B. Configure an SNMP community string on the cluster.
- C. Configure a firewall policy and allow SNMP.
- D. Configure a trap host on the cluster.
Answer: A,D
NEW QUESTION 84
In a 4-node cluster, what are two functions of the HA interconnect? (Choose two.)
- A. It provides the ability to relocate the aggregate ownership.
- B. It provides the ability to synchronize the cluster configuration.
- C. It provides nondisruptive operations and fault tolerance.
- D. It provides the ability to migrate a data aggregate to any node in the cluster.
Answer: A,C
NEW QUESTION 85
Click the Exhibit button.
You are adding new DS224C shelves in a new stack to your cluster with FAS8060 controllers running ONTAP 9.7.
Referring to the exhibit, which two actions should be performed to the cluster before installing the new shelves? (Choose two.)
- A. Move the SAS cables to a new stack.
- B. Disable out-of-band ACP.
- C. Remove the Ethernet cables.
- D. Enable in-band ACP.
Answer: A,B
NEW QUESTION 86
You install a 4-node cluster with an AFF A400 HA pair and a FAS8300 HA pair. After setup, you are asked to review the audit logs on each controller from a Web browser.
In this scenario, which method provides access to the logs from a Web browser?
- A. DNS
- B. SPI
- C. ACP
- D. ADP
Answer: B
NEW QUESTION 87
When completing a new ONTAP 9.5 cluster base installation, which three SVM types will be present on the system by default? (Choose three.)
- A. data SVM
- B. node SVM
- C. admin SVM
- D. cluster SVM
- E. system SVM
Answer: B,C,E
NEW QUESTION 88
You have an AFF A400 cluster that is running ONTAP 9.7 software. You are asked to set up FlexCache for NFS volumes.
In this scenario, which statement is correct when implementing FlexCache?
- A. A site license is required.
- B. No license is required.
- C. A subscription license is required.
- D. A capacity license is required.
Answer: D
Explanation:
Explanation/Reference: https://www.netapp.com/pdf.html?item=/media/7336-tr4743.pdf (27)
NEW QUESTION 89
Click the Exhibit button.
You are reviewing the setup of a recently installed FAS9000 switched cluster. As shown in the exhibit, the cluster interconnects are connected to a pair of Cisco Nexus 3132Q-V 40 Gb ports.
For a high availability, which ports should swap Ethernet cables?
- A. Swap node2:e4a and node2:e8a.
- B. Swap node1:e4a and node2:e4b.
- C. Swap node1:e4a and node1:e8a.
- D. Swap node1:e8a and node2:e4a.
Answer: A
NEW QUESTION 90
You are preparing for a new installation. While determining the most suitable version of ONTAP software to deploy, you want to verify the ONTAP 9 release cadence to ensure that you are deploying a Long Term Service (LTS) release.
In this scenario, where would you find this information?
- A. Visit the Hardware Universe site.
- B. Visit the NetApp Support site.
- C. Visit the ONTAP 9 Documentation Center site.
- D. Visit the Interoperability Matrix Tool site.
Answer: C
NEW QUESTION 91
You are a NetApp Professional Services engineer, employed by NetApp. You have just completed an ONTAP cluster installation. You need to collect the relevant configuration information to enable the Service Event Report (SER) to be created.
Which tool would you use to accomplish this task?
- A. NetAppDocs output report
- B. ONTAP System Manager
- C. Active IQ scheduled reports
- D. Active IQ Config Advisor worksheet
Answer: C
NEW QUESTION 92
You are adding new controllers to an existing cluster. As part of the upgrade process, you have updated the BES-53248 cluster switches.
In this scenario. Which two commands would you use to verify a healthy cluster after the upgrade? (Choose two.)
- A. network port show -ipspace Cluster
- B. network interface show -vserver Cluster -fields auto-revert
- C. network interface show -vserver Cluster
- D. network device-discovery show -protocol cdp
Answer: A,C
NEW QUESTION 93
According to NetApp best practices, how many NTP servers should you associate with an ONTAP cluster?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
NEW QUESTION 94
Click the Exhibit button.
You are reviewing the setup of a recently installed FAS9000 switched cluster. As shown in the exhibit, the cluster interconnects are connected to a pair of Cisco Nexus 3132Q-V 40 Gb ports.
For a high availability, which ports should swap Ethernet cables?
- A. Swap node2:e4a and node2:e8a.
- B. Swap node1:e4a and node2:e4b.
- C. Swap node1:e4a and node1:e8a.
- D. Swap node1:e8a and node2:e4a.
Answer: A
NEW QUESTION 95
You just installed a new AFF A220 2-node cluster without additional disk shelves. When you review the Config Advisor output, you notice that your SAS cabling appears to be single-path HA.
In this scenario, which statement is true?
- A. AFF A220 controllers with internal disks support only single-path HA.
- B. Cable controller 1 0a to controller 2 0a, and cable controller 1 0b to controller 2 0b.
- C. The Config Advisor version you are using requires a plugin for AFF controllers.
- D. Cable controller 1 0a to controller 2 0b, and cable controller 1 0b to controller 2 0a.
Answer: D
NEW QUESTION 96
Which type of partitioning would you use when installing a FAS8200 with 24 SAS drives running ONTAP 9.5?
- A. root-root-data-data partitioning
- B. root-data-data partitioning
- C. root-root-data partitioning
- D. root-data partitioning
Answer: D
NEW QUESTION 97
You are completing an ONTAP base installation, and your customer is asking you to create two SVMs, one for NFS and one for SMB.
Which type of SVM needs to be created to complete the installation?
- A. data SVM
- B. multitenancy node SVM
- C. admin SVM
- D. system SVM
Answer: A
NEW QUESTION 98
......
Resources From:
- 2021 Latest Fast2test NS0-183 Exam Dumps (PDF & Exam Engine) Free Share: https://www.fast2test.com/NS0-183-premium-file.html
Free Resources from Fast2test, We Devoted to Helping You 100% Pass All Exams!