Verified & Correct NSE7_EFW-6.4 Practice Test Reliable Source Jan 20, 2023 Updated
Free Fortinet NSE7_EFW-6.4 Exam Files Downloaded Instantly
NEW QUESTION 17
View the exhibit, which contains the partial output of an IKE real-time debug, and then answer the question below.
Which statements about this debug output are correct? (Choose two.)
- A. The remote gateway IP address is 10.0.0.1.
- B. The initiator has provided remote as its IPsec peer ID.
- C. The negotiation is using AES128 encryption with CBC hash.
- D. It shows a phase 1 negotiation.
Answer: B,D
NEW QUESTION 18
What conditions are required for two FortiGate devices to form an OSPF adjacency? (Choose three.)
- A. OSPF costs match.
- B. OSPF IP MTUs match.
- C. Hello and dead intervals match.
- D. IP addressesare in the same subnet.
- E. OSPF peer IDs match.
Answer: B,C,D
Explanation:
Explanation
https://help.fortinet.com/fos50hlp/54/Content/FortiOS/fortigate-advanced-routing-54/Routing_OSPF/OSPF_Bac
NEW QUESTION 19
Examine the output of the 'get router info bgp summary' command shown in the exhibit; then answer the question below.
Which statements are true regarding the output in the exhibit? (Choose two.)
- A. The local BGP peer has received a total of 3 BGP prefixes.
- B. BGP state of the peer 10.125.0.60 is Established.
- C. BGP peer 10.200.3.1 has never been down since the BGP counters were cleared.
- D. Local BGP peer has not received an OpenConfirm from 10.200.3.1.
Answer: B,D
NEW QUESTION 20
An LDAP user cannot authenticate against a FortiGate device. Examine the real time debug output shown in the exhibit when the user attempted the authentication; thenanswer the question below.
Based on the output in the exhibit, what can cause this authentication problem?
- A. The FortiGate has been configured with the wrong authentication schema.
- B. The FortiGate has been configured with thewrong password for the LDAP administrator.
- C. User student is using a wrong password.
- D. User student is not found in the LDAP server.
Answer: D
NEW QUESTION 21
An administrator has decreased all the TCP session timers to optimize the FortiGate memory usage. However, after the changes, one network application started to have problems. During the troubleshooting, the administrator noticed that the FortiGate deletes the sessions after the clients send the SYN packets, and before the arrival of the SYN/ACKs. When the SYN/ACK packets arrive to the FortiGate, the unit has already deleted the respective sessions. Which TCP session timer must be increased to fix this problem?
- A. TCP half close.
- B. TCP time wait.
- C. TCP half open.
- D. TCP session time to live.
Answer: C
Explanation:
http://docs-legacy.fortinet.com/fos40hlp/43prev/wwhelp/wwhimpl/common/html/wwhelp.htm?context=fgt&file=CLI_get_Commands.58.25.html
The tcp-halfopen-timer controls for how long, after a SYN packet, a session without SYN/ACK remains in the table.
The tcp-halfclose-timer controls for how long, after a FIN packet, a session without FIN/ACK remains in the table.
The tcp-timewait-timer controls for how long, after a FIN/ACK packet, a session remains in the table. A closed session remains in the session table for a few seconds more to allow any out-of-sequence packet.
NEW QUESTION 22
An administrator cannot connect to the GIU of a FortiGate unit with the IP address 10.0.1.254. The administrator runs the debug flow while attempting the connection using HTTP. The output of the debug flow is shown in the exhibit:
Based on the error displayed by the debug flow, which are valid reasons for this problem? (Choose two.)
- A. The packet is denied because of reverse path forwarding check.
- B. Redirection of HTTP to HTTPS administrative access is disabled.
- C. HTTP administrative access is disabled in the FortiGate interface with the IP address 10.0.1.254.
- D. HTTP administrative access is configured with a port number different than 80.
Answer: C,D
NEW QUESTION 23
Two independent FortiGate HA clusters are connected to the same broadcast domain. The administrator has reported that both clusters are using the same HA virtual MAC address. This creates a duplicated MAC address problem in the network. What HA setting must be changed in one of the HA clusters to fix the problem?
- A. Session pickup.
- B. Group ID.
- C. Gratuitous ARPs.
- D. Group name.
Answer: B
Explanation:
Explanation
https://help.fortinet.com/fos50hlp/54/Content/FortiOS/fortigate-high-availability-52/HA_failoverVMAC.htm
NEW QUESTION 24
Examine the following partial output from two system debug commands; then answer the question below.
Which of the following statements are true regarding the above outputs? (Choose two.)
- A. The unit is running a 32-bit FortiOS
- B. The Cached value is always the Active value plus the Inactive value
- C. The unit is in kernel conserve mode
- D. Kernel indirectly accesses the low memory (LowTotal) through memorypaging
Answer: A,B
NEW QUESTION 25
Examine the output of the 'diagnose ips anomaly list' command shown in the exhibit; then answer the question below.
Which IP addresses are included in the output of thiscommand?
- A. Those whose traffic matches an IPS sensor.
- B. Those whose traffic matches a DoS policy.
- C. Those whose traffic exceeded a threshold of a matching DoS policy.
- D. Those whose traffic was detected as an anomaly by an IPS sensor.
Answer: B
NEW QUESTION 26
Refer to the exhibit, which contains the output of diagnose sys session list.
If the HA ID for the primary unit is zero (0), which statement about the output is true?
- A. This session cannot be synced with the slave unit.
- B. The inspection of this session has been offloaded to the slave unit.
- C. The master unit is processing this traffic.
- D. This session is for HA heartbeat traffic.
Answer: C
NEW QUESTION 27
Examine the following partial output from two system debug commands; then answer the question below.
Which of the following statements are true regarding the above outputs? (Choose two.)
- A. The unit is running a 32-bit FortiOS
- B. Kernel indirectly accesses the low memory (LowTotal) through memory paging
- C. The Cached value is always the Active value plus the Inactive value
- D. The unit is in kernel conserve mode
Answer: A,C
NEW QUESTION 28
View the exhibit, which contains the output of a diagnose command, and the answer the question below.
Which statements are true regarding the Weight value?
- A. Its value is incremented with each packet lost.
- B. Its initial value is statically set to 10.
- C. Its initial value is calculated based on the round trip delay (RTT).
- D. It determines which FortiGuard server is used for license validation.
Answer: A
NEW QUESTION 29
View the following FortiGate configuration.
All traffic to theInternet currently egresses from port1. The exhibit shows partial session information for Internet traffic from a user on the internal network:
If the priority on route ID 1 were changed from 5 to 20, what would happen to traffic matching that user's session?
- A. The session would be deleted, so the client would need to start a new session.
- B. The session would remain in the session table, but its traffic would now egress from both port1 and port2.
- C. The session would remain in the session table, and its traffic would still egress from port1.
- D. The session would remain in thesession table, and its traffic would start to egress from port2.
Answer: C
Explanation:
Explanation
http://kb.fortinet.com/kb/documentLink.do?externalID=FD40943
NEW QUESTION 30
Examine the partial output from the IKE real time debug shown in the exhibit; then answer the question below.
Why didn't the tunnel come up?
- A. Theremote gateway's Phase-2 configuration does not match the local gateway's phase-2 configuration.
- B. The remote gateway's Phase-1 configuration does not match the local gateway's phase-1 configuration.
- C. IKE mode configuration is not enabled in the remote IPsec gateway.
- D. One IPsec gateway is using main mode, while theother IPsec gateway is using aggressive mode.
Answer: B
NEW QUESTION 31
View the exhibit, which contains the output of a real-time debug, Which statement about this output is true?
Which of the following statements is true regarding this output?
- A. FortiGate found the requested URL in its local cache.
- B. This web request was inspected using the ftgd-allow web filler profile.
- C. The requested URL belongs to category ID 255.
- D. The server hostname Is training, fortinet.com.
Answer: A
NEW QUESTION 32
Examine the output from the 'diagnose vpn tunnel list' command shown in the exhibit; then answer the question below.
Which command can be used to sniffer the ESP traffic for the VPN DialUP_0?
- A. diagnose sniffer packet any 'port 500'
- B. diagnose sniffer packet any 'host 10.0.10.10'
- C. diagnose sniffer packet any 'port 4500'
- D. diagnose sniffer packet any 'esp'
Answer: C
Explanation:
NAT-T is enabled. natt: mode=silent Protocol ESP is used. ESP is encapsulated in UDP port 4500 when NAT-T is enabled.
NEW QUESTION 33
Examine the output from the 'diagnose debug authd fsso list' command; then answer the question below.
# diagnose debug authd fsso list -FSSO logons-IP: 192.168.3.1 User: STUDENT Groups: TRAININGAD/USERS Workstation: INTERNAL2. TRAINING. LAB The IP address 192.168.3.1 is NOT the one used by the workstation INTERNAL2. TRAINING. LAB.
What should the administrator check?
- A. The source IP address of the traffic arriving to the FortiGate from the workstation INTERNAL2. TRAINING. LAB.
- B. The IP address recorded in the logon event for the user STUDENT.
- C. The reserve DNS lookup forthe IP address 192.168.3.1.
- D. The DNS name resolution for the workstation name INTERNAL2. TRAINING. LAB.
Answer: A
NEW QUESTION 34
Examine the following partialoutput from a sniffer command; then answer the question below.
What is the meaning of the packets dropped counter at the end of the sniffer?
- A. Number of packets that matched the sniffer filter but could not be captured by the sniffer.
- B. Number of packets that didn't match the sniffer filter.
- C. Number of packets that matched the sniffer filter and were dropped by the FortiGate.
- D. Number of total packets dropped by the FortiGate.
Answer: A
Explanation:
Explanation
https://kb.fortinet.com/kb/documentLink.do?externalID=11655
NEW QUESTION 35
......
How much Fortinet NSE7_EFQ-6.4: Fortinet NSE 7 - Enterprise Firewall 6.4 Exam Cost
The Fortinet NSE7_EFQ-6.4: Fortinet NSE 7 - Enterprise Firewall 6.4 Exam Costs USD 400. As the exam costs may vary country or region vise, it is always recommended to check the official website to see what's the cost of the exam for your country. The total cost for preparing for the exam will include study materials as well as NSE7 EFW-6.4 exam dumps and NSE7 EFW-6.4 practice exams. Refer to the official website by clicking here for more info on pricing.
Pass Fortinet NSE7_EFW-6.4 exam Dumps 100 Pass Guarantee With Latest Demo: https://www.fast2test.com/NSE7_EFW-6.4-premium-file.html