New 2021 200-301 exam questions Welcome to download the newest Fast2test 200-301 PDF dumps (216 Q&As)
P.S. Free 2021 CCNA 200-301 dumps are available on Google Drive shared by Fast2test
NEW QUESTION 127
Refer to the exhibit.
Which route type is configured to reach the internet?
- A. default route
- B. floating static route
- C. host route
- D. network route
Answer: A
NEW QUESTION 128
Refer to the exhibit.
A packet is being sent across router R1 to host 172.163.3.14. To which destination does the router send the packet?
- A. 207.165.200.250 via Serial/0/0/0
- B. 207.165.200.254 via Serial0/0/0
- C. 207.165.200.246 via Serial0/1/0
- D. 207.165.200.254 via Serial0/0/1
Answer: D
NEW QUESTION 129
Refer to the exhibit.
which path is used by the router for internet traffic ?
- A. 0.0.0.0/0
- B. 10.10.13.0/24
- C. 10.10.10.0/28
- D. 209.165.200.0/27
Answer: A
NEW QUESTION 130
Drag the descriptions of IP protocol transmissions from the left onto the IP traffic types on the right.
Answer:
Explanation:
Explanation
TCP
* Sends tranmissions in sequence
4. Transmits packets individually
6. Uses a lower transmission rate to ensure relability
UDP
5. Uses a higher transmission rate to support latency-sensitive application
2. Transmissions include an 8-byte header
3. Transmits packets as a stream
NEW QUESTION 131
Drag the descriptions of device management from the left onto the types of device management on the right.
Answer:
Explanation:
Explanation:
Cisco DNA Center Device Management
3. Monitor the cloud for software update
5. Uses CLI templates to apply a consistent configuration to multiple devices at an individual location
6. Uses NetFlow to analyse potential security threats throughout the network and take appropriate action on that traffic Traditional device management
2. Manages device configuration on a per-device basis
4. Security is managed near the perimeter of the network with firewalls, VPNs, and IPS
* Implements changes via an SSH terminal
NEW QUESTION 132
What are two benefits of controller-based networking compared to traditional networking? (Choose two.)
- A. controller-based increases network bandwidth usage, while traditional lightens the load on the network
- B. controller-based allows for fewer network failures, while traditional increases failure rates
- C. controller-based inflates software costs, while traditional decreases individual licensing costs
- D. controller-based provides centralization of key IT functions, while traditional requires distributed management functions
- E. controller-based reduces network configuration complexity, while traditional increases the potential for errors
Answer: D,E
Explanation:
Section: Automation and Programmability
NEW QUESTION 133
An engineer must configure a /30 subnet between two routes. Which usable IP address and subnet mask combination meets this criteria?
- A. interface e0/0
description to HQ-A370:98968
ip address 10.2.1.3 255.255.255.252 - B. interface e0/0
description to HQ-A370:98968
ip address 172.16.1.4 255.255.255.248 - C. interface e0/0
description to HQ-A370:98968
ip address 209.165.201.2 225.255.255.252 - D. interface e0/0
description to HQ-A370:98968
ip address 192.168.1.1 255.255.255.248
Answer: C
Explanation:
Section: Network Fundamentals
NEW QUESTION 134
You have configured a router with an OSPF router ID, but its IP address still reflects the physical interface.
Which action can you take to correct the problem in the least disruptive way?
- A. Specify a loopback address
- B. Reload the OSPF process.
- C. Reboot the router.
- D. Save the router configuration
Answer: A
NEW QUESTION 135
Drag the descriptions of IP protocol transmissions from the left onto the IP traffic types on the right.
Answer:
Explanation:
Explanation
TCP
* Sends tranmissions in sequence
4. Transmits packets individually
6. Uses a lower transmission rate to ensure relability
UDP
5. Uses a higher transmission rate to support latency-sensitive application
2. Transmissions include an 8-byte header
3. Transmits packets as a stream
NEW QUESTION 136
which port security mode can assist with troubleshooting by keeping count of violations?
- A. restrict
- B. shutdown
- C. protect
- D. access
Answer: A
NEW QUESTION 137
Which two best practices protect your network from VLAN hopping attacks? (choose two)
- A. Configure dynamic ARP inspection
- B. Configure port security
- C. Change the native VLAN to an unused VLAN ID
- D. Assign all access ports to VLANS other than the native VLAN
- E. Configure an ACL to prevent traffic from changing VLANS.
Answer: C,D
NEW QUESTION 138
A network engineer is configuring an OSPFv2 neighbor adjacency Drag and drop the parameters from the left onto their required categories on the right. Not all parameters are used
Answer:
Explanation:
NEW QUESTION 139
Drag and drop the SNMP manager and agent identifier commands from the left onto the functions on the right
Answer:
Explanation:
NEW QUESTION 140
Which command on a port enters the forwarding state immediately when a PC is connected to it?
- A. switch(config-if)#no spanning-tree portfast
- B. switch(config)#spanning-tree portfast bpduguard default
- C. switch(config)#spanning-tree portfast default
- D. switch(config-if)#spanning-tree portfast trunk
Answer: D
NEW QUESTION 141
Which access layer threat-mitigation technique provides security based on identity?
- A. Dynamic ARP Inspection
- B. 802.1x
- C. using a non-default native VLAN
- D. DHCP snooping
Answer: B
NEW QUESTION 142
Which two conditions must be met before SSH can operate normally on a Cisco IOS switch? (Choose two.)
- A. A console password must be configured on the switch.
- B. The ip domain-name command must be configured on the switch.
- C. IP routing must be enabled on the switch.
- D. Telnet must be disabled on the switch.
- E. The switch must be running a k9 (crypto) IOS image.
Answer: B,E
NEW QUESTION 143
Refer to the exhibit.
The default-information originate command is configured under the R1 OSPF configuration After testing workstations on VLAN 20 at Site B cannot reach a DNS server on the Internet Which action corrects the configuration issue?
- A. Configure the ip route 0.0.0.0 0.0.0.0 10.10.10.2 command on R2
- B. Add the default-information originate command onR2
- C. Configure the ip route 0.0.0.0 0.0.0.0 10.10.10.18 command on R1
- D. Add the always keyword to the default-information originate command on R1
Answer: D
NEW QUESTION 144
Refer to the exhibit.
The default-information originate command is configured under the R1 OSPF configuration After testing workstations on VLAN 20 at Site B cannot reach a DNS server on the Internet Which action corrects the configuration issue?
- A. Configure the ip route 0.0.0.0 0.0.0.0 10.10.10.2 command on R2
- B. Add the default-information originate command onR2
- C. Configure the ip route 0.0.0.0 0.0.0.0 10.10.10.18 command on R1
- D. Add the always keyword to the default-information originate command on R1
Answer: D
NEW QUESTION 145
Refer to the exhibit.
PC1 is trying to ping PC3 for the first time and sends out an ARP to S1 Which action is taken by S1?
- A. It forwards it out interface G0/2 only.
- B. It drops the frame.
- C. It is flooded out every port except G0/0.
- D. It forwards it out G0/3 only
Answer: C
NEW QUESTION 146
Refer to the exhibit.
An administrator must configure interfaces Gi1/1 and Gi1/3 on switch SW11 PC-1 and PC-2 must be placed in the Data VLAN and Phone-1 must be placed in the Voice VLAN Which configuration meets these requirements?
- A. Option A
- B. Option B
- C. Option C
- D. Option D
Answer: C
NEW QUESTION 147
Refer to the exhibit. Which route does R1 select for traffic that is destined to 192 168.16.2?
- A. 192.168 26.0/26
- B. 192.168.16.0/21
- C. 192.168.16.0/24
- D. 192.168.16.0/27
Answer: D
Explanation:
The destination IP addresses match all four entries in the routing table but the 192.168.16.0/27 has the longest prefix so it will be chosen. This is called the "longest prefix match" rule.
NEW QUESTION 148
An engineer configures interface Gi1/0 on the company PE router to connect to an ISP Neighbor discovery is disabled
Which action is necessary to complete the configuration if the ISP uses third-party network devices?
- A. Disable Cisco Discovery Protocol on the interface
- B. Disable autonegotiation
- C. Enable LLDP globally
- D. Enable LLDP-MED on the ISP device
Answer: D
NEW QUESTION 149
The GRE tunnel between r3 and Branch 1 is down.
Which cause of the issue is true?
- A. The tunnel source loopback0 interface is not advertised into EIGRP in R3
- B. The EIGRP neighbor relationship was no formed due the IP address being misconfigured between the R2 and R3 interfaces
- C. The EIGRP neighbor relationship was not formed due to EIGRP packets blocked by inbound ACL on R3
- D. The tunnel source loopback0 interface is not advertised into EIGRP in Branch1.
Answer: C
NEW QUESTION 150
Drag and Drop Question
Refer to the exhibit. Drag and drop the networking parameters from the left on to the correct values on the right.
Select and Place:
Answer:
Explanation:
NEW QUESTION 151
......
200-301 exam questions from Fast2test dumps: https://www.fast2test.com/200-301-premium-file.html (216 Q&As)
Free 2021 CCNA 200-301 dumps are available on Google Drive shared by Fast2test: https://drive.google.com/open?id=1y2wY4iA3gdnJGLnuPL7MOc9mjP08HG8c