Use Real HPE0-V14 - 100% Cover Real Exam Questions [Oct-2021]
Dumps Brief Outline Of The HPE0-V14 Exam - Fast2test
NEW QUESTION 108
HPE Support asks you to generate an SSD wear gauge report for local storage on an HPE DL360 Gen10 server running VMware.
Which procedure will ensure that the server will boot directly into a maintenance state so you can generate the requested report?
- A. Use Always On functionality of Intelligent Provisioning
- B. Changing the one-time boot option to Smart Storage Administrator in iLO web-based user interface
- C. Click Boot to System Setup Utilities in iLO web-based user interface
- D. Changing the one-time boot option to Intelligent Provisioning in HPE OneView
- E. Changing the one-time boot option to Intelligent Provisioning in iLO web-based user interface
Answer: E
Explanation:
Reference:
https://support.hpe.com/hpesc/public/docDisplay?docId=emr_na-a00051235en_us
NEW QUESTION 109
A customer needs to support both network and storage traffic on their network, which includes Ethernet, iSCSi, and Fibre Channel devices. The customer is concerned about the large amount of cables coming from the various cards inserted in their rack servers, as well as the operational costs in their data center.
Which component addresses these issues?
- A. Fibre Channel host bus adapter
- B. Dual-port 10 GbE FlexLOM
- C. Converged network adapter
- D. Dynamic Smart Array controller
Answer: C
NEW QUESTION 110
A solution integrator is installing new equipment to the rack.
Click the recommended location for HPE R/T3000 Extended Runtime Module.
Hot Area:
Answer:
Explanation:
NEW QUESTION 111
Read the question, and then refer to the exhibit.
display int Ten-GigabitEthernet 1/0/1 Ten-GigabitEthernet1/0/1 Current state: UP Line protocol state: UP IP packet frame type: Ethernet II, hardware address: d894-03fb-793d Description: Ten-GigabitEthernet1/0/1 Interface Bandwidth: 10000000 kbps Loopback is not set Media type is stack wire, port hardware type is STACK SFP_PLUS 10Gbps-speed mode, full-duplex mode Link speed type is autonegotiation, link duplex type is autonegotiation Flow-control is not enabled Maximum frame length: 10000 Allow jumbo frames to pass Broadcast max- ratio: 100% Multicast max-ratio: 100% Unicast max-ratio: 100% PVID: 1 MDI type:
Automdix Port link-type: Trunk VLAN Passing: 10 VLAN permitted: 10 Trunk port encapsulation: IEEE 802.1q Port priority: 0 <SNIP> An administrator connected a hypervisor to interface Ten-Gigabit Ethernet1/0/1 in a switch. The administrator created virtual machines in VLAN 10 and 20 on the hypervisor. These VLANs are configured to be tagged on the hypervisor.
The administrator found that all the virtual machines within VLAN 20 can communicate with each other, but not to any resource on VLAN 20 outside the hypervisor.
What must you do to resolve this issue?
- A. Configure the PVID of the interface to be VLAN 20.
- B. Configure the interface as an access port.
- C. Configure the interface as an IRF port.
- D. Permit VLAN 20 on the interface.
Answer: A
NEW QUESTION 112
What is an access port on an Ethernet switch?
- A. A port that carries FCP frames inside the network
- B. A port that carries untagged frames inside the network
- C. A port that carries mulitple VLANs
- D. A port that is connected to an FCF
Answer: B
NEW QUESTION 113
HPE Support asks you to generate an SSD wear gauge report for local storage on an HPE DL360 Gen10 server running VMware.
Which procedure will ensure that the server will boot directly into a maintenance state so you can generate the requested report?
- A. Use Always On functionality of Intelligent Provisioning
- B. Changing the one-time boot option to Intelligent Provisioning in iLO web-based user interface
- C. Changing the one-time boot option to Smart Storage Administrator in iLO web-based user interface
- D. Click Boot to System Setup Utilities in iLO web-based user interface
- E. Changing the one-time boot option to Intelligent Provisioning in HPE OneView
Answer: C
Explanation:
Explanation/Reference: https://support.hpe.com/hpesc/public/docDisplay?docId=emr_na-a00051235en_us
NEW QUESTION 114
A customer needs a new VMware environment for a critical stock trading application and will need high performance compute and low latency storage.
Identify the correct component configurations on the left and drag them to the answer area on the right. (Choose two.)
Answer:
Explanation:
ANS - Xeon-platinum , af20
https://ark.intel.com/content/www/us/en/ark/compare.html?productIds=123546,192482
NEW QUESTION 115
When should you choose to populate a server with LRDlMMs?
- A. when error correction is the most important factor
- B. when price is the most important factor
- C. when memory capacity is the most important factor
- D. when memory speed is the most important factor
Answer: D
NEW QUESTION 116
HPE Support asks you to generate an SSD wear gauge report for local storage on an HPE DL360 Gen10 server running VMware.
Which procedure will ensure that the server will boot directly into a maintenance state so you can generate the requested report?
- A. Use Always On functionality of Intelligent Provisioning
- B. Changing the one-time boot option to Intelligent Provisioning in iLO web-based user interface
- C. Changing the one-time boot option to Smart Storage Administrator in iLO web-based user interface
- D. Click Boot to System Setup Utilities in iLO web-based user interface
- E. Changing the one-time boot option to Intelligent Provisioning in HPE OneView
Answer: C
NEW QUESTION 117
Which protocol can be used to access a shared directory on a network-attached storage device?
- A. SMB
- B. SNMP
- C. BGP
- D. FCP
Answer: A
NEW QUESTION 118
Given the solution shown in the exhibit, which adapter is required in the server to facilitate connective in Block 1
Answer:
Explanation:
NEW QUESTION 119
Which factors are used to determine RAM configuration maximum memory capacity? (Choose two.)
- A. number and model of qualified processors
- B. number of cores in the processor
- C. largest DIMM capacity qualified on the server
- D. speed of the DIMMs being used
- E. number of PCIe slots
Answer: A,C
NEW QUESTION 120
A security client needs a surveillance solution to support 239 Cameras. They expect to generate 2PB of data and require a 10Gb network infrastructure in a single rack.
Which solution should you recommend to meet the customer requirements?
- A. HPE Apollo Servers
- B. HPE Moonshot
- C. HPE MSA
- D. HPE SimplVity 380
Answer: A
Explanation:
Reference: https://h20195.www2.hpe.com/v2/GetPDF.aspx/4AA0-6064ENW.pdf
NEW QUESTION 121
A customer needs to provide inventory management, health monitoring, status alerting, and reporting for their ProLiant servers.
Which HPE management offering meets the customer's needs?
- A. Insight Online
- B. Insight Remote Support
- C. OneView
- D. InfoSight
Answer: C
NEW QUESTION 122
A customer is subject to regulatory requirements and their data is highly sensitive.
Which HPE Smart Array feature addresses their need for an level of security for data stored inside their server?
- A. Smart Battery backed-up write-cache
- B. Secure Encryption
- C. Rapid Parity Initialization
- D. SmartCache
Answer: B
NEW QUESTION 123
You are installing a combined server and storage solution at a customer location. What must you keep in mind regarding the typical requirements for the location? (Choose two.)
- A. Rack doors must be unlocked for easy component removal and maintenance
- B. Rack tie kit should be installed on the rack for proper airflow
- C. Room temperature must not exceed 35 C (95 F)
- D. There must be at least a 10 cm (4 in) clearance space at the front and back of the components within the racks
- E. UPSs should be installed at the top of the rack for top mounted power feed
Answer: C,D
NEW QUESTION 124
Refer to the exhibit.
Drag the correct protocols from the left to the appropriate area on the topology on the right.
Answer:
Explanation:
NEW QUESTION 125
When is it appropriate for a customer to implement HPE OneView Standard?
- A. To monitor their services
- B. To enable the Advanced iLO license
- C. To update firmware
- D. To manage multiple servers
Answer: A
Explanation:
Reference: https://h20195.www2.hpe.com/v2/GetPDF.aspx/c04111367.pdf
NEW QUESTION 126
Which web service uses baste CRUD operations performed on resources using HTTP Post, Get. Put. Delete, and Patch?
- A. cURL
- B. SOAP
- C. REST
- D. CORBA
Answer: C
NEW QUESTION 127
......
Certification Training for HPE0-V14 Exam Dumps Test Engine: https://www.fast2test.com/HPE0-V14-premium-file.html